Sketcher requirement for a sketch/pl: Difference between revisions

From FreeCAD Documentation
(Created page with "To, że krzywa zamknięta jest obecna, nie jest oczywiste i nie jest łatwe do rozpoznania. Podczas łączenia łuku kołowego z linią prostą, np. może mieć miejsce sytuac...")
No edit summary
Line 6: Line 6:
|Author=[[User:Maker|Maker]]
|Author=[[User:Maker|Maker]]
|Time=
|Time=
|FCVersion=
|FCVersion= dowolna
}}
}}



Revision as of 15:48, 29 March 2021

Ćwiczenie
Temat
Szkicownik
Poziom trudności
Początkujący
Czas wykonania
Autorzy
Maker
Wersja FreeCAD
dowolna
Pliki z przykładami
Nie dołączono
Zobacz również
-

Minimalne wymagania dotyczące szkicu

Tworzenie bryły w środowisku pracy Projekt części jest już możliwe i osiągalne "tylko" za pomocą krzywej zamkniętej (profilu). Całkowite określenie wszystkich wymiarów i właściwości ("w pełni związane") nie jest jeszcze wymagane.

To, że krzywa zamknięta jest obecna, nie jest oczywiste i nie jest łatwe do rozpoznania. Podczas łączenia łuku kołowego z linią prostą, np. może mieć miejsce sytuacja że dwa punkty końcowe są tworzone tylko jeden nad drugim. Należy użyć wiązania zbieżności, po to aby utworzyć pojedynczy punkt, który faktycznie łączy prostą i łuk.

A simple sketch. Left: Curve only in four places (red, automatic constraints when drawing with Polyline) closed. Middle: Warning - ... broken face (broken curve). Right: Curve closed at remaining four places (green)

However, consistent parametric working means that the sketch is completely determined.

Defining a sketch completely

Even a relatively simple sketch may contain dozens of indeterminacies (indicated in the combo view as a "degrees of freedom" number). To eliminate them together at the end is a relatively confusing task.

A simple sketch; completely determined by 25 constraints, of which only 5 are dimension constraints.

This work is clearer and simpler if one immediately eliminates the "freedoms" of each added geometric element, i. this dimensions (that is, values for dimensions and placements). The provisional completeness is reached if all lines are displayed in green.

If one waits until the end of the drawing to determine, one finds remaining "freedoms" by touching the points and lines with the mouse pointer and determining where they are not yet fixed. When complete, the entire drawing is displayed in green.

If you accidentally create an "overmodulation", a warning appears in the combo-view asking you to undo the corresponding actions (constraints).