Szkicownik: Utwórz polilinię

From FreeCAD Documentation
Revision as of 12:08, 18 March 2023 by Kaktus (talk | contribs) (Created page with "==Użycie==")

Szkicownik: Utwórz polilinię

Lokalizacja w menu
Szkic → Elementy geometryczne szkicownika → Utwórz polilinię
Środowisko pracy
Szkicownik
Domyślny skrót
G M
Wprowadzono w wersji
-
Zobacz także
Szkicownik: Linia

Opis

To narzędzie działa podobnie jak narzędzie Utwórz linię, ale tworzy ciągłe odcinki linii i łuków połączone wierzchołkami. Po uruchomieniu narzędzia kursor myszki zmienia kształt na biały krzyż z czerwoną ikoną polilinii. Oprócz niego na niebiesko w czasie rzeczywistym wyświetlane są współrzędne kursora.

Polilinia zaczynała się od linii, łuku stycznego, łuku prostopadłego następnie linii stycznej.

Użycie

The polyline always starts with a straight line segment: click - move the mouse - click. Move the mouse again. After placing the first line segment, the Sketcher polyline tool has multiple modes that can be toggled with the M key. For example you can draw tangent or perpendicular arcs following a line or arc segment. Repeatedly pressing the M key toggles through these different modes:

  1. Press the M key: the new segment is a line which is perpendicular to the previous segment.
  2. Press the M key again: the new segment is a line which is tangential to the previous segment.
  3. Press the M key again: the new segment is an arc which is tangential to the previous segment.
  4. Press the M key again: the new segment is an arc which is perpendicular (left) to the previous segment.
  5. Press the M key again: the new segment is an arc which is perpendicular(right) to the previous segment.
  6. Press the M key again: You are again in the state where you started; the line is only connected with a coincidence to the previous segment.
  • version 0.18 and above While in any of the arc modes, holding down the Ctrl key (MacOS: CMD key) and moving the cursor causes the arc to snap by increments of 45 degrees, relative to the previously created polyline segment.
  • Pick points on an empty area of the 3D view, or on an existing object (auto constraints must be active in TaskView).
  • Pressing Esc or clicking the right mouse button before closing the polyline to a loop ends the current polyline and you can continue with a new one. Pressing Esc or clicking the right mouse button again ends the polyline function.
  • Pressing Esc or clicking the right mouse button after closing the polyline to a loop ends the polyline function.