Sketcher CreatePolyline/es

From FreeCAD Documentation
This page is a translated version of the page Sketcher CreatePolyline and the translation is 20% complete.
Outdated translations are marked like this.

Sketcher CreatePolyline

Ubicación en el Menú
Croquizador→ Geometrías del croquizador → Crear polilínea
Entornos de trabajo
Croquizador
Atajo de teclado por defecto
Ninguno
Introducido en versión
-
Ver también
Línea

Descripción

Esta herramienta trabaja como la herramienta Línea, pero crea segmentos de líneas continuos conectados por sus vértices.

Cuando se inicia la herramienta, el puntero del ratón cambia a una cruz blanca con un icono de polilínea rojo. Las coordenadas del puntero se muestran al lado de este en color azul en tiempo real.

Polyline started with a line, a tangent arc, a perpendicular arc then a tangent line.

Utilización

See also: Drawing aids.

  1. There are several ways to invoke the tool:
    • Press the Create polyline button.
    • Select the Sketcher → Sketcher geometries → Create polyline option from the menu.
    • Right-click in the 3D view and select the Create polyline option from the context menu.
    • Use the keyboard shortcut: G then M.
  2. The cursor changes to a cross with the tool icon.
  3. A polyline always starts with a straight line segment: pick two points to define this segment.
  4. Optionally press the M key one or more times to cycle through the modes for the next segment. The available modes are:
    • Line perpendicular to the previous segment.
    • Line tangential to the previous segment.
    • Arc tangential to the previous segment.
    • Arc perpendicular (left) to the previous segment.
    • Arc perpendicular (right) to the previous segment.
    • Line only connected to the previous segment. This is the initial mode again.
  5. While in any of the arc modes, optionally hold down the Ctrl key to snap the arc to increments of 45° relative to the previous segment.
  6. Pick the endpoint of the segment.
  7. Optionally repeat this to create more segments.
  8. To finish the input do one of the following:
    • Snap to the start point to create a closed polyline.
    • Right-click or press Esc to create an open polyline.
  9. The polyline segments have been created and applicable constraints have been added.
  10. If the tool runs in continue mode:
    1. Optionally keep creating polylines.
    2. To finish, right-click or press Esc, or start another geometry or constraint creation tool.