Widok połączony

From FreeCAD Documentation
Revision as of 21:29, 3 February 2020 by Kaktus (talk | contribs) (Created page with "Następnie należy aktywować widok za pomocą menu, {{MenuCommand|Widok → Panele → Widok drzewa}} lub {{MenuCommand|→ Właściwości widoku}}.")

Wprowadzenie

Widok połączony jest jednym z głównych paneli w interfejsie FreeCAD . Domyślnie znajduje się on po lewej stronie ekranu. Składa się z dwóch części:
górna część ma dwie zakładki dla właściwości Model i Zadania,
dolna część pokazuje edytor właściwości, który również wyświetla dwie zakładki dla właściwości Widok i Dane.
Edytor właściwości jest wyświetlany tylko wtedy, gdy aktywna jest zakładka Model, czyli gdy widoczny jest widok drzewa.

Pierwotnie górna część (widoku drzewa) była oddzielona od dolnej części (edytora właściwości), ale następnie zostały one połączone i w ten sposób powstał widok połączony.

Aby używać tych widoków należy użyć edytora parametrów. Jeśli nie istnieją stwórz następujące podgrupy:

  • BaseApp/Preferences/DockWindows/TreeView
  • BaseApp/Preferences/DockWindows/PropertyView

następnie dodaj parametr Enabled typu Boolean, i ustaw jego wartość na true.

Następnie należy aktywować widok za pomocą menu, Widok → Panele → Widok drzewa lub → Właściwości widoku.

Upper section

The Model tab shows the tree view, which is a representation of the document's content, including 2D and 3D geometry with their parametric history, but also supporting objects that contain data saved in the document.

The Tasks tab shows the task panel, which will show different actions depending on the active workbench, and the active tool.

The combo view has two tabs: the Model tab that controls displaying the tree view and the property editor, and the Tasks tab that controls showing the task panel.

Lower section

The lower part of the combo view shows the property editor, which displays two tabs for View and Data properties. The property editor is only shown when the Model tab is active, that is, when the tree view is visible.

The View tab shows visualization properties of the objects, which only affect their appearance in the 3D view.

The Data tab shows the parametric properties of the objects, which determine how the geometrical shapes are defined.

The lower part of the combo view is the property editor, which shows View and Data properties.

Template:Interface/pl