Sketcher Offset/pl: Difference between revisions

From FreeCAD Documentation
(Created page with "{{Caption|Równoległe krawędzie wokół zamkniętej (O) i otwartej (U) polilinii konstrukcyjnej.}}")
(Created page with "==Użycie==")
Line 30: Line 30:
{{Caption|Równoległe krawędzie wokół zamkniętej (O) i otwartej (U) polilinii konstrukcyjnej.}}
{{Caption|Równoległe krawędzie wokół zamkniętej (O) i otwartej (U) polilinii konstrukcyjnej.}}


<span id="Usage"></span>
<div lang="en" dir="ltr" class="mw-content-ltr">
==Usage==
==Użycie==
</div>


<div lang="en" dir="ltr" class="mw-content-ltr">
<div lang="en" dir="ltr" class="mw-content-ltr">

Revision as of 10:26, 12 December 2023

Other languages:

Szkicownik: Odsunięcie geometrii

Lokalizacja w menu
Szkic → Narzędzia szkicownika → Odsunięcie geometrii
Środowisko pracy
Szkicownik
Domyślny skrót
Z T
Wprowadzono w wersji
0.22
Zobacz także
brak

Opis

Narzędzie Odsunięcie geometrii rysuje równoodległe krawędzie wokół wybranych krawędzi. Po uruchomieniu narzędzia kursor myszki zmienia się w biały krzyżyk z czerwoną ikoną odsunięcia: .

Równoległe krawędzie wokół zamkniętej (O) i otwartej (U) polilinii konstrukcyjnej.

Użycie

  1. Select one or more edges.
  2. There are several ways to invoke the command:
    • Press the Offset geometry button.
    • Select the Sketcher → Sketcher tools → Offset geometry option from the menu.
    • The keyboard shortcut: Z then T.
  3. An Offset parameters section is added at the top of the Sketcher Task panel.
  4. Optionally change the Mode combobox from Arc (default) to Intersection.
  5. Optionally check the Delete original geometries checkbox to only keep the new outline.
  6. Optionally check the Add offset constraint checkbox to add a dimensional constraint between the offset outline and the original geometry.
  7. Drag the cursor and click, or enter a distance to set the offset and finish the command. This also removes the Offset parameters section from the Task panel.

If Add offset constraint was activated the offset can be adjusted by changing the dimensional constraint.