Sketcher CreateRectangle/pl: Difference between revisions

From FreeCAD Documentation
(Updating to match new version of source page)
(Created page with "==Uwagi==")
Line 38: Line 38:
* Naciśnięcie klawisza {{KEY|Esc}} lub kliknięcie prawym przyciskiem myszy anuluje tę funkcję.
* Naciśnięcie klawisza {{KEY|Esc}} lub kliknięcie prawym przyciskiem myszy anuluje tę funkcję.


==Notes==
<span id="Notes"></span>
==Uwagi==


* When launched the rectangle tools add a '''Rectangle parameters''' section at the top of the Sketcher [[Task_panel|Task panel]] ({{Version|0.22}}). It contains:
* When launched the rectangle tools add a '''Rectangle parameters''' section at the top of the Sketcher [[Task_panel|Task panel]] ({{Version|0.22}}). It contains:

Revision as of 14:41, 2 January 2024

Szkicownik: Utwórz prostokąt

Lokalizacja w menu
Szkic → Elementy geometryczne szkicownika → Utwórz prostokąt
Środowisko pracy
Szkicownik
Domyślny skrót
G R
Wprowadzono w wersji
-
Zobacz także
Zaokrąglony prostokąt, Linia łamana

Opis

Narzędzie to rysuje prostokąt, wybierając dwa przeciwstawne punkty. Po uruchomieniu narzędzia wskaźnik myszy zmienia się w biały krzyż z czerwoną prostokątną ikoną. Na bieżąco wyświetlane są obok niego współrzędne wskaźnika w kolorze niebieskim.

Aby zdefiniować prostokąt za pomocą punktu środkowego i punktu na krawędzi, użyj narzędzia Utwórz wyśrodkowany prostokąt.

Użycie

  • Po naciśnięciu przycisku na pasku narzędzi Utwórz prostokąt, kliknij raz, aby ustawić pierwszy narożnik, a następnie przesuń kursor myszki i kliknij drugi raz, aby ustawić przeciwległy narożnik.
  • Naciśnięcie klawisza Esc lub kliknięcie prawym przyciskiem myszy anuluje tę funkcję.

Uwagi

  1. A Mode spinbox to chose one of the modes to draw the rectangle:
    • Corner, length & width
    • Center, length & width
    • 3 corners
    • Center and two corners
  2. A Rounded corners checkbox to apply round corners to the rectangle.
  3. A Frame checkbox to add a contour with a constant offset to the (rounded) rectangle.
  • All three buttons in this selection now launch the same tool but with different preset combinations of mode and options that can still be altered after the first click.
  • If Rounded corners is enabled, the offset is inward, and the offset value is larger than the corner radius, the offset contour will be created without fillets.
  • The modes 3 corners, and Center and two corners create parallelograms rather than rectangles.