Sketcher CreateArcOfEllipse/pl: Difference between revisions

From FreeCAD Documentation
(Created page with "==Szczególe cechy==")
(Created page with "{{Docnav/pl |Utwórz elipsę przez trzy punkty |Utwórz łuk na podstawie hiperboli |środowisko pracy Szkicownik |IconL=Sketcher_CreateEllipseBy3Points.svg |IconR=Sketcher_CreateArcOfHyperbola.svg |IconC=Workbench_Sketcher.svg }}")
Line 43: Line 43:
* Moving the arc of ellipse by edge is the same as moving ellipse's center.
* Moving the arc of ellipse by edge is the same as moving ellipse's center.


{{Docnav
{{Docnav/pl
|[[Sketcher_CreateEllipseBy3Points|Ellipse by 3 points]]
|[[Sketcher_CreateEllipseBy3Points/pl|Utwórz elipsę przez trzy punkty]]
|[[Sketcher_CreateArcOfHyperbola|Arc of hyperbola]]
|[[Sketcher_CreateArcOfHyperbola/pl|Utwórz łuk na podstawie hiperboli]]
|[[Sketcher_Workbench|Sketcher]]
|[[Sketcher_Workbench/pl|środowisko pracy Szkicownik]]
|IconL=Sketcher_CreateEllipseBy3Points.svg
|IconL=Sketcher_CreateEllipseBy3Points.svg
|IconR=Sketcher_CreateArcOfHyperbola.svg
|IconR=Sketcher_CreateArcOfHyperbola.svg

Revision as of 09:33, 18 March 2023

Szkicownik: Utwórz łuk na podstawie elipsy

Lokalizacja w menu
Szkic → Elementy geometryczne szkicownika → Utwórz łuk na podstawie elipsy
Środowisko pracy
Szkicownik
Domyślny skrót
G E A
Wprowadzono w wersji
0.15
Zobacz także
Utwórz elipsę przez środek, Komponent utwórz łuk

Opis

Narzędzie to rysuje łuk elipsy wybierając cztery punkty: środek, koniec promienia głównego, punkt początkowy i punkt końcowy. Po uruchomieniu narzędzia kursor myszki zmienia się w biały krzyż z czerwoną ikoną łuku elipsy. Poza tym wyświetlane są współrzędne w czasie rzeczywistym.

Kolejność kliknięć wskazują żółte strzałki z numerami.
C to środek, a średnica główna, b średnica mała, F1 i F2 to punkty centralne.

Użycie

  • Press the Create an arc of ellipse button.
  • First click in 3D view sets ellipse center. Second click sets the first radius and orientation of the ellipse. Third click sets the other radius and the start of the arc. The fourth click sets the end of the arc.
  • After the fourth click, the arc of ellipse is created, together with a set of construction geometry aligned to it (major diameter, minor diameter, two foci). The construction geometry can be manually deleted if not needed, and recreated later. See Internal Alignment Constraint and Sketcher Show Hide Internal Geometry.
  • Pressing ESC or clicking the right mouse button cancels the function.

Szczególe cechy

  • Major and minor axes of underlying ellipse are strict and cannot be swapped by resizing. The underlying ellipse must be rotated to swap the axes.
  • Unlike ellipse that can be constrained to become a circle, ellipse arc cannot represent an arc of circle.
  • Moving the arc of ellipse by edge is the same as moving ellipse's center.