Sketcher CreateArcOfEllipse/pl: Difference between revisions

From FreeCAD Documentation
(Created page with "Narzędzie to rysuje łuk elipsy wybierając cztery punkty: środek, koniec promienia głównego, punkt początkowy i punkt końcowy. Po uruchomieniu narzędzia kursor myszki zmienia się w biały krzyż z czerwoną ikoną łuku elipsy. Poza tym wyświetlane są współrzędne w czasie rzeczywistym.")
(Created page with "{{Caption|Kolejność kliknięć wskazują żółte strzałki z numerami.<br> '''C''' to środek, '''a''' średnica główna, '''b''' średnica mała, '''F1''' i '''F2''' to punkty centralne.}}")
Line 25: Line 25:


[[File:Sketcher_ArcOfEllipseExample1.png‎|none|500px]]
[[File:Sketcher_ArcOfEllipseExample1.png‎|none|500px]]
{{Caption|Kolejność kliknięć wskazują żółte strzałki z numerami.<br>
{{Caption|The sequence of clicks is indicated by yellow arrows with numbers.<br>
'''C''' to środek, '''a''' średnica główna, '''b''' średnica mała, '''F1''' i '''F2''' to punkty centralne.}}
C is the center, a the major diameter, b the minor diameter, F1 and F2 are foci.}}


==Usage==
==Usage==

Revision as of 09:32, 18 March 2023

Szkicownik: Utwórz łuk na podstawie elipsy

Lokalizacja w menu
Szkic → Elementy geometryczne szkicownika → Utwórz łuk na podstawie elipsy
Środowisko pracy
Szkicownik
Domyślny skrót
G E A
Wprowadzono w wersji
0.15
Zobacz także
Utwórz elipsę przez środek, Komponent utwórz łuk

Opis

Narzędzie to rysuje łuk elipsy wybierając cztery punkty: środek, koniec promienia głównego, punkt początkowy i punkt końcowy. Po uruchomieniu narzędzia kursor myszki zmienia się w biały krzyż z czerwoną ikoną łuku elipsy. Poza tym wyświetlane są współrzędne w czasie rzeczywistym.

Kolejność kliknięć wskazują żółte strzałki z numerami.
C to środek, a średnica główna, b średnica mała, F1 i F2 to punkty centralne.

Usage

  • Press the Create an arc of ellipse button.
  • First click in 3D view sets ellipse center. Second click sets the first radius and orientation of the ellipse. Third click sets the other radius and the start of the arc. The fourth click sets the end of the arc.
  • After the fourth click, the arc of ellipse is created, together with a set of construction geometry aligned to it (major diameter, minor diameter, two foci). The construction geometry can be manually deleted if not needed, and recreated later. See Internal Alignment Constraint and Sketcher Show Hide Internal Geometry.
  • Pressing ESC or clicking the right mouse button cancels the function.

Peculiarities

  • Major and minor axes of underlying ellipse are strict and cannot be swapped by resizing. The underlying ellipse must be rotated to swap the axes.
  • Unlike ellipse that can be constrained to become a circle, ellipse arc cannot represent an arc of circle.
  • Moving the arc of ellipse by edge is the same as moving ellipse's center.