Projekt Części: Addytywny torus

From FreeCAD Documentation
Revision as of 07:51, 17 June 2023 by Kaktus (talk | contribs) (Created page with "==Opcje==")

Projekt Części: Addytywny torus

Lokalizacja w menu
Projekt Części → Utwórz cechę przez dodanie → Addytywny torus
Środowisko pracy
Projekt Części
Domyślny skrót
brak
Wprowadzono w wersji
0.17
Zobacz także
Komponent bryła pierwotna do dodania, Subtraktywny torus

Opis

Wstawia pierwotny torus do aktywnej Zawartości jako pierwszy element lub łączy go z istniejącymi elementami.

Użycie

  1. Naciśnij przycisk Addytywny torus. Uwaga: Addytywny torus jest częścią menu narzędzi o nazwie Utwórz bryłę pierwotną do dodania. Po uruchomieniu programu FreeCAD, Addytywny prostopadłościan wyświetlany jest na pasku narzędzi domyślnie. Aby przejść do funkcji Torus, kliknij strzałkę w dół na widocznej ikonce i wybierz z menu opcję Addytywny walec.
  2. Ustaw parametry bryły i dołączenia.
  3. Kliknij OK.
  4. Pod aktywnym obiektem Zawartość pojawi się element Torus.

Opcje

Torus można edytować po jego utworzeniu na dwa sposoby:

  • Klikając go dwukrotnie w drzewie modelu lub klikając prawym przyciskiem myszy i wybierając Edytuj bryłę pierwotną z menu podręcznego. Spowoduje to wyświetlenie parametrów bryły pierwotnej.
  • Poprzez Edytor właściwości.

Właściwości

  • DANEAttachment: defines the attachment mode as well as the Attachment Offset. See Part EditAttachment.
  • DANELabel: Label given to the Torus object. Change to suit your needs.
  • DANERadius1: Radius of the imaginary orbit around which the circular cross-section revolves. (The distance between the center of the torus and the center of the revolving cross section)
  • DANERadius2: Radius of the circular cross-section defining the form of the torus.
  • DANEAngle1: (labelled V parameter in the Primitive parameters) lower truncation of the torus, parallel to the circular cross section (-180 degrees in a full torus). A bug in the sources causes unexpected results at changing Angle1.
  • DANEAngle2: (unlabelled in the Primitive parameters) upper truncation of the ellipsoid, parallel to the circular cross section (180 degrees in a full torus). A bug in the sources causes unexpected results at changing Angle2.
  • DANEAngle3: (labelled U parameter in the Primitive parameters) angle of rotation of the circular cross section (360 degrees in a full torus).