Projekt Części: Addytywna elipsoida

From FreeCAD Documentation
Revision as of 07:14, 17 June 2023 by Kaktus (talk | contribs) (Created page with "==Właściwości==")

PartDesign AdditiveEllipsoid

Menu location
Projekt Części → Utwórz cechę przez dodanie → Addytywna elipsoida
Workbenches
Projekt Części
Default shortcut
None
Introduced in version
0.17
See also
Komponent bryła pierwotna do dodania, Subtraktywna elipsoida

Opis

Wstawia pierwotną elipsoidę do aktywnej Zawartości jako pierwszy element lub łączy ją z istniejącymi elementami.

Użycie

  1. Naciśnij przycisk Addytywna elipsoida. Uwaga: Addytywna elipsoida jest częścią menu narzędzi o nazwie Utwórz bryłę pierwotną do dodania. Po uruchomieniu programu FreeCAD, Addytywna elipsoida wyświetlana jest na pasku narzędzi domyślnie. Aby przejść do funkcji Elipsoia, kliknij strzałkę w dół na widocznej ikonce i wybierz z menu opcję Addytywny walec.
  2. Ustaw parametry bryły i dołączenia.
  3. Kliknij OK.
  4. Pod aktywnym obiektem Zawartość pojawi się element Prostopadłościanu.

Opcje

Elipsoidę można edytować po jej utworzeniu na dwa sposoby:

  • Klikając ją dwukrotnie w drzewie modelu lub klikając prawym przyciskiem myszy i wybierając Edytuj bryłę pierwotną z menu podręcznego. Spowoduje to wyświetlenie parametrów bryły pierwotnej.
  • Poprzez Edytor właściwości.

Właściwości

  • DANEAttachment: defines the attachment mode as well as the Attachment Offset. See Part EditAttachment.
  • DANELabel: label given to the Ellipsoid object. Change to suit your needs.
  • DANERadius1: the radius value along the ellipsoid's vertical axis; by default, parallel to the Z-axis.
  • DANERadius2: the radius value along the ellipsoid's length; by default, parallel to the X-axis.
  • DANERadius3: the radius value along the ellipsoid's width; by default, parallel to the Y-axis. At the default value of zero, the ellipsoid forms an oblate spheroid. This has the same form as if Radius3 is identical to Radius2.
  • DANEAngle1: (labelled V parameter in the Primitive parameters) lower truncation of the ellipsoid, parallel to the circular cross section (-90 degrees in a full spheroid)
  • DANEAngle2: (unlabelled in the Primitive parameters) upper truncation of the ellipsoid, parallel to the circular cross section (90 degrees in a full spheroid).
  • DANEAngle3: (labelled U parameter in the Primitive parameters) angle of rotation of the elliptical cross section (360 degrees in a full spheroid).