Projekt Części: Subtraktywny torus

From FreeCAD Documentation
Revision as of 05:52, 18 June 2023 by Kaktus (talk | contribs) (Created page with "==Użycie==")

Projekt Części: Subtraktywny torus

Lokalizacja w menu
Projekt Części → Utwórz cechę przez odjęcie → Subtraktywny torus
Środowisko pracy
Projekt Części
Domyślny skrót
brak
Wprowadzono w wersji
0.17
Zobacz także
Komponent bryła pierwotna do odjęcia, Addytywny torus

Opis

Funkcja ta wstawia pierwotny torus odejmowany od aktywnej Zawartości. Jego kształt jest odejmowany od istniejącej bryły.

Po lewej: aktywna zawartość (A) pokazana w kolorze szarym i torus do odjęcia (B) pokazany w kolorze czerwonym z przeźroczystością. Wynik po prawej.

Użycie

  1. Press the Subtractive Torus button. Note: the Subtractive Torus is part of an icon menu labelled Create an additive primitive. After launching FreeCAD, the Subtractive Box is the one displayed in the toolbar. To get the Torus, click on the down arrow besides the visible icon and select Subtractive Torus in the menu.
  2. Set the Primitive parameters and Attachment.
  3. Click OK.
  4. A Torus feature appears under the active Body.

Options

The Torus can be edited after its creation in two ways:

  • Double-clicking it in the Model tree, or by right-clicking and selecting Edit primitive in the contextual menu; this brings up the Primitive parameters.
  • Via the Property editor.

Properties

  • DANEAttachment: defines the attachment mode as well as the Attachment Offset. See Part EditAttachment.
  • DANELabel: Label given to the Torus object. Change to suit your needs.
  • DANERadius1: Radius of the imaginary orbit around which the circular cross-section revolves. (The distance between the center of the torus and the center of the revolving cross section)
  • DANERadius2: Radius of the circular cross-section defining the form of the torus.
  • DANEAngle1: (labelled V parameter in the Primitive parameters) lower truncation of the torus, parallel to the circular cross section (-180° in a full torus). A bug in the sources causes unexpected results at changing Angle1.
  • DANEAngle2: (unlabelled in the Primitive parameters) upper truncation of the ellipsoid, parallel to the circular cross section (180° in a full torus). A bug in the sources causes unexpected results at changing Angle2.
  • DANEAngle3: (labelled U parameter in the Primitive parameters) angle of rotation of the circular cross section (360° in a full torus).