Draft Snap Perpendicular/pl: Difference between revisions

From FreeCAD Documentation
(Created page with "==Użycie==")
(Created page with "Ogólne informacje na temat przyciągania można znaleźć na stronie Przyciąganie.")
Line 30: Line 30:
==Użycie==
==Użycie==


Ogólne informacje na temat przyciągania można znaleźć na stronie [[Draft_Snap/pl|Przyciąganie]].
For general information about snapping see [[Draft_Snap|Draft Snap]].


# Make sure snapping is enabled. See [[Image:Draft_Snap_Lock.svg|16px]] [[Draft_Snap_Lock|Draft Snap Lock]].
# Make sure snapping is enabled. See [[Image:Draft_Snap_Lock.svg|16px]] [[Draft_Snap_Lock|Draft Snap Lock]].

Revision as of 18:00, 6 September 2023

Rysunek Roboczy: Przyciągnij prostopadle

Lokalizacja w menu
brak
Środowisko pracy
Rysunek Roboczy, Architektura
Domyślny skrót
brak
Wprowadzono w wersji
-
Zobacz także
Przyciąganie, Przełącz przyciąganie

Opis

Funkcja Przyciągnij prostopadle przyciąga prostopadłe rzuty poprzedniego punktu na powierzchnie (dostępne w wersji 0.21) i krawędzie. Ściany i krawędzie mogą należeć do obiektów środowiska Rysunek Roboczy lub Architektura, ale także do obiektów utworzonych za pomocą innych środowisk pracy.

Ta opcja przyciągania znajdzie również punkty na przedłużeniach powierzchni i krawędzi.

Przyciąganie drugiego punktu linii do prostopadłego punktu na przedłużonej krawędzi

Użycie

Ogólne informacje na temat przyciągania można znaleźć na stronie Przyciąganie.

  1. Make sure snapping is enabled. See Draft Snap Lock.
  2. If Draft Snap Perpendicular is not active do one of the following:
    • Press the button in the Draft snap toolbar.
    • Hold down the button in the Draft snap widget and in the menu that opens select the Snap Perpendicular option.
  3. Choose a Draft or Arch command to create your geometry.
  4. Note that you can also change snap options while a command is active.
  5. Pick a first point. This snap option requires a previous point. The perpendicular point will be determined in relation to this point.
  6. Move the cursor over a face or edge.
  7. The face or edge is highlighted.
  8. If a perpendicular point is found the point is marked and the icon is displayed near the cursor.
  9. If there are multiple perpendicular points: optionally move the cursor closer to another perpendicular point. introduced in version 0.21
  10. Click to confirm the point.

Preferences

See Draft Snap.