Rysunek Roboczy: Przyciągnij ortogonalnie

From FreeCAD Documentation
Revision as of 06:47, 28 December 2023 by Kaktus (talk | contribs) (Created page with "Polecenie 24px '''Przyciągnij ortogonalnie''' przyciąga do umownych linii, które przecinają poprzedni punkt pod kątem wielokrotności 45°. Linie i kąty odnoszą się do płaszczyzny XY układu współrzędnych płaszczyzny roboczej.")

Rysunek Roboczy: Przyciągnij ortogonalnie

Lokalizacja w menu
brak
Środowisko pracy
Rysunek Roboczy, Architektura
Domyślny skrót
brak
Wprowadzono w wersji
-
Zobacz także
Przyciąganie, Przełącz przyciąganie

Opis

Polecenie Przyciągnij ortogonalnie przyciąga do umownych linii, które przecinają poprzedni punkt pod kątem wielokrotności 45°. Linie i kąty odnoszą się do płaszczyzny XY układu współrzędnych płaszczyzny roboczej.

Snapping the second point of a line to an imaginary line that has an angle of 45° with the X axis. The small magenta circles indicate all possible directions.

Usage

For general information about snapping see Draft Snap.

  1. Make sure snapping is enabled. See Draft Snap Lock.
  2. If Draft Snap Ortho is not active do one of the following:
    • Press the button in the Draft snap toolbar.
    • Press the button in the Draft snap widget.
  3. Choose a Draft or Arch command to create your geometry.
  4. Note that you can also change snap options while a command is active.
  5. Pick a first point. This snap option requires a previous point.
  6. If you move the cursor around the previous point you will notice a "magnetic" effect when the cursor is on an imaginary infinite line crossing that point at an angle of 0°, 45°, 90° or 135°.
  7. The point is marked and the icon is displayed near the cursor.
  8. Click to confirm the point.

Preferences

See Draft Snap.