Draft Snap Center/pl: Difference between revisions

From FreeCAD Documentation
(Created page with "{{Caption|Przyciąganie drugiego punktu linii do środka okrągłej krawędzi.}}")
(Created page with "{{Caption|Przyciąganie drugiego punktu linii do punktu umiejscowienia łuku części budowli.}}")
Line 26: Line 26:


[[Image:Draft_Snap_Center_example_buildingpart.png]]
[[Image:Draft_Snap_Center_example_buildingpart.png]]
{{Caption|Przyciąganie drugiego punktu linii do punktu umiejscowienia łuku części budowli.}}
{{Caption|Snapping the second point of a line to the Placement point of an Arch BuildingPart}}


== Usage ==
== Usage ==

Revision as of 12:07, 27 December 2023

Rysunek Roboczy: Przyciągnij do środka

Lokalizacja w menu
brak
Środowisko pracy
Rysunek Roboczy, Architektura
Domyślny skrót
brak
Wprowadzono w wersji
-
Zobacz także
Przyciąganie, Przełącz przyciąganie

Opis

Opcja Draft Snap Center przyciąga do punktu środkowego ścian i okrągłych krawędzi oraz do punktu DANEUmiejscowienia obiektów Pośrednia płaszczyzna robocza i Architektura: Część budowl. Powierzchnie i krawędzie mogą należeć do obiektów środowiska pracy Rysunek Roboczy lub Architektura, ale także do obiektów utworzonych za pomocą innych środowisk pracy.

Przyciąganie drugiego punktu linii do środka okrągłej krawędzi.

Przyciąganie drugiego punktu linii do punktu umiejscowienia łuku części budowli.

Usage

For general information about snapping see Draft Snap.

  1. Make sure snapping is enabled. See Draft Snap Lock.
  2. If Draft Snap Center is not active do one of the following:
    • Press the button in the Draft snap toolbar.
    • Hold down the button in the Draft snap widget and in the menu that opens select the Snap Center option.
  3. Choose a Draft or Arch command to create your geometry.
  4. Note that you can also change snap options while a command is active.
  5. Do one of the following:
    • To select the center point of a face or circular edge:
      • Move the cursor over the face or edge.
      • The face or edge is highlighted.
    • To select the DANEPlacement point of a Draft WorkingPlaneProxy:
      • Move the cursor over any element of the working plane proxy.
      • The working plane proxy is not highlighted.
    • To select the DANEPlacement point of an Arch BuildingPart:
      • Move the cursor over one of the edges of the small axis symbol of the BuildingPart, or over the text next to it that displays the DANELabel of the BuildingPart and its level.
      • Only the edges of the axis symbol are highlighted. The text is not highlighted.
  6. If a point is found the point is marked and the icon is displayed near the cursor.
  7. Click to confirm the point.

Preferences

See Draft Snap.