Rysunek Roboczy: Przyciągnij do kąta

From FreeCAD Documentation
Revision as of 12:34, 27 December 2023 by Kaktus (talk | contribs) (Created page with "Opcja 24px '''Draft Snap Angle''' przyciąga do specjalnych punktów głównych na okrągłych krawędziach, przy wielokrotnościach 30° i 45°. Krawędzie mogą należeć do obiektów środowiska pracy Rysunek Roboczy lub Architektura, ale także do obiektów stworzonych w innych środowiskach pracy.")

Rysunek Roboczy: Przyciągnij do kąta

Lokalizacja w menu
brak
Środowisko pracy
Rysunek Roboczy, Architektura
Domyślny skrót
brak
Wprowadzono w wersji
-
Zobacz także
Przyciąganie, Przełącz przyciąganie

Opis

Opcja Draft Snap Angle przyciąga do specjalnych punktów głównych na okrągłych krawędziach, przy wielokrotnościach 30° i 45°. Krawędzie mogą należeć do obiektów środowiska pracy Rysunek Roboczy lub Architektura, ale także do obiektów stworzonych w innych środowiskach pracy.

Snapping the second point of a line to the -30° point on a circular edge. The small magenta circles indicate all available special cardinal points.

Usage

For general information about snapping see Draft Snap.

  1. Make sure snapping is enabled. See Draft Snap Lock.
  2. If Draft Snap Angle is not active do one of the following:
    • Press the button in the Draft snap toolbar.
    • Hold down the button in the Draft snap widget and in the menu that opens select the Snap Angle option.
  3. Choose a Draft or Arch command to create your geometry.
  4. Note that you can also change snap options while a command is active.
  5. Move the cursor over a circular edge.
  6. The edge is highlighted.
  7. If a cardinal point is found the point is marked and the icon is displayed near the cursor.
  8. Optionally move the cursor closer to another cardinal point to select that point instead.
  9. Click to confirm the point.

Preferences

See Draft Snap.