Rysunek Roboczy: Przyciągnij równolegle

From FreeCAD Documentation
Revision as of 18:21, 27 December 2023 by Kaktus (talk | contribs) (Created page with "Polecenie 24px '''Przyciągnij równolegle''' przyciąga do wyimaginowanej linii równoległej do prostych krawędzi. Krawędzie mogą należeć do obiektów środowiska Rysunek Roboczy lub Architektura, ale także do obiektów utworzonych za pomocą innych środowisk pracy.")

Rysunek Roboczy: Przyciągnij równolegle

Lokalizacja w menu
brak
Środowisko pracy
Rysunek Roboczy, Architektura
Domyślny skrót
brak
Wprowadzono w wersji
-
Zobacz także
Przyciąganie, Przełącz przyciąganie

Opis

Polecenie Przyciągnij równolegle przyciąga do wyimaginowanej linii równoległej do prostych krawędzi. Krawędzie mogą należeć do obiektów środowiska Rysunek Roboczy lub Architektura, ale także do obiektów utworzonych za pomocą innych środowisk pracy.

Up to 2 (or 8 introduced in version 0.20) edges can be referenced by this snap option and Draft Snap Extension, making it possible to snap to virtual intersections. Both snap options can also be combined with other snap options.

Snapping the second point of a line to an invisible line that is parallel to an edge

Usage

For general information about snapping see Draft Snap.

  1. Make sure snapping is enabled. See Draft Snap Lock.
  2. If Draft Snap Parallel is not active do one of the following:
    • Press the button in the Draft snap toolbar.
    • Hold down the button in the Draft snap widget and in the menu that opens select the Snap Parallel option.
  3. Choose a Draft or Arch command to create your geometry.
  4. Note that you can also change snap options while a command is active.
  5. Pick a first point. This snap option requires a previous point. The parallel snap line will pass through this point.
  6. Move the cursor over a straight edge.
  7. The edge is highlighted.
  8. If you now move the cursor around the previous point you will notice a "magnetic" effect when the cursor is on the parallel snap line.
  9. The point is marked and the icon is displayed near the cursor.
  10. Click to confirm the point.

Preferences

See Draft Snap.