Siatka: Utwórz segmenty z najlepiej dopasowanych powierzchni

From FreeCAD Documentation
Revision as of 16:22, 17 December 2022 by Kaktus (talk | contribs) (Created page with "Polecenie '''Utwórz segmenty z najlepiej dopasowanych powierzchni''' tworzy oddzielne segmenty siatki dla określonych typów powierzchni obiektu siatkowego. Polecenie może...")
Other languages:

Siatka Utwórz segmenty z najlepiej dopasowanych powierzchni

Lokalizacja w menu
Siatki → Utwórz segmenty z najlepiej dopasowanych powierzchni ...
Środowisko pracy
Siatka
Domyślny skrót
brak
Wprowadzono w wersji
-
Zobacz także
Utwórz segmenty siatki

Opis

Polecenie Utwórz segmenty z najlepiej dopasowanych powierzchni tworzy oddzielne segmenty siatki dla określonych typów powierzchni obiektu siatkowego. Polecenie może również zidentyfikować ich parametry, co może być przydatne podczas ponownego projektowania obiektu siatkowego.

Usage

  1. If you plan to identify the parameters of a surface type, note that the command uses the color red to mark the faces selected for this option. To see them properly:
    • The WIDOKDisplay Mode of the mesh object ideally should be Flat lines, but should at least show faces. If necessary use the Std DrawStyle command to override this property.
    • The WIDOKShape Color of the mesh object should not be red.
  2. Select a single mesh object.
  3. There are several ways to invoke the command:
    • Press the Mesh SegmentationBestFit button.
    • Select the Meshes → Create mesh segments from best-fit surfaces... option from the menu.
  4. The Mesh segmentation task panel opens.
  5. Optionally press one of the Parameters... buttons to identify the parameters of a surface:
    • The Surface fit dialog box opens.
    • Select one or more faces belonging to the surface:
      • Press the Region button and while holding down the left mouse button draw a region, a closed spline, in the 3D view. Faces that (partially) fall inside the region will be selected.
      • Press the Triangle button to select individual faces.
      • Optionally press the Clear button to clear the selection.
    • Press the Compute button to calculate the parameters.
    • Press the OK or Cancel button to close the dialog box.
  6. Select the surface type(s) you wish to create mesh segments for:
    • Plane
    • Cylinder
    • Sphere
  7. Specify the Tolerance values.
  8. Specify the Minimum number of faces values.
  9. Press the OK button.
  10. The command will create a group containing separate mesh objects, each a segment of the original mesh object.
  11. If the created group is empty try using the command again with modified settings.