FEM ConstraintContact/pl: Difference between revisions

From FreeCAD Documentation
(Created page with "# Jest kilka sposobów wywołania tej komendy: #* Wciśnij przycisk {{Button|16px Kontakt}}. #* Wybierz opcję {{MenuCommand|Model → Warunki brzegowe i obciążenia mechaniczne → 16px Kontakt}} z menu. # Wybierz powierzchnię master. # Wybierz powierzchnię slave. # Wprowadź sztywność kontaktu. # Wprowadź współczynnik tarcia.")
(Created page with "==Ograniczenia==")
Line 34: Line 34:
# Wprowadź współczynnik tarcia.
# Wprowadź współczynnik tarcia.


==Limitations==
<span id="Limitations"></span>
==Ograniczenia==


* The contact constraint can only be applied to two faces.
* The contact constraint can only be applied to two faces.

Revision as of 14:24, 16 November 2023

FEM ConstraintContact

Lokalizacja w menu
Model → Warunki brzegowe i obciążenia mechaniczne → Kontakt
Środowisko pracy
MES
Domyślny skrót
brak
Wprowadzono w wersji
-
Zobacz także
Warunek brzegowy utwierdzenia

Opis

Tworzy więz kontaktowy między 2 powierzchniami.

Użycie

  1. Jest kilka sposobów wywołania tej komendy:
    • Wciśnij przycisk Kontakt.
    • Wybierz opcję Model → Warunki brzegowe i obciążenia mechaniczne → Kontakt z menu.
  2. Wybierz powierzchnię master.
  3. Wybierz powierzchnię slave.
  4. Wprowadź sztywność kontaktu.
  5. Wprowadź współczynnik tarcia.

Ograniczenia

  • The contact constraint can only be applied to two faces.
  • Development for multiple contact at once: https://forum.freecadweb.org/viewtopic.php?f=18&t=15699&start=130#p303275
  • Because multiple meshes are currently not supported, contact must be applied to faces that are separated by (at least) a small distance. If the faces were touching (no gap between them), the result of a boolean union or boolean fragments operation (necessary to avoid having multiple meshes which is not allowed at the moment) would be a continuous mesh and thus no need to use contact anymore. See Forum discussion.

Notes

Tips for modeling

  • From: https://forum.freecadweb.org/viewtopic.php?f=18&p=340874#p340494
  • The use of linear elements is recommended. Otherwise, calculations can be very time-consuming.
  • Master/slave assignment:
    • The larger of the two surfaces should act as the master surface.
    • If the surfaces are of comparable size, the surface on the stiffer body should act as the master surface.
    • If the surfaces are of comparable size and stiffness, the surface with the coarser mesh should act as the master surface.

CalculiX

  • A very detailed CalculiX contact example. (link)
  • An interesting example found in the FreeCAD German subforum. (link)