Sketcher Split/de: Difference between revisions

From FreeCAD Documentation
(Created page with "Dieses Werkzeug erlaubt eine Kante in zwei identische Teile zu teilen, wobei die meisten Beschränkungen dupliziert werden, so dass beide Teile bis auf die Teilungspunktlage b...")
(Created page with "* Für Ellipse, Parabel, Hyperbel und B-Splines wird der Prozess noch nicht unterstützt.")
Line 34: Line 34:
== Begrenzungen ==
== Begrenzungen ==


* Für Ellipse, Parabel, Hyperbel und B-Splines wird der Prozess noch nicht unterstützt.
* For ellipse, parabola, hyperbola and B-splines the action is not yet supported.


== Hinweise ==
== Hinweise ==

Revision as of 06:40, 13 August 2021

Skizzierer Teilen

Menüeintrag
Skizze → Skizzierer Geometrien → Teilen
Arbeitsbereich
Skizzierer
Standardtastenkürzel
Keiner
Eingeführt in Version
0.20
Siehe auch
Skizzierer Stutzen

Beschreibung

Dieses Werkzeug erlaubt eine Kante in zwei identische Teile zu teilen, wobei die meisten Beschränkungen dupliziert werden, so dass beide Teile bis auf die Teilungspunktlage beschränkt bleiben. Im speziellen Fall eines Kreises wird dieser in einen Bogen mit losen Enden umgewandelt, wobei die bestehenden Kreisbeschränkungen auf den neuen Bogen übertragen werden.

Anwendung

  1. Press the Split button. The mouse pointer turns into a white cross with a red split symbol.
  2. Click on the edge in the place where you want to split it.
  3. From the line and arc edges, two new will be created, connected at the point clicked. A circle is converted to an arc with the very same center point and other constraints the original circle had.
  4. Pressing Esc or pressing the right mouse button will terminate the function.

Begrenzungen

  • Für Ellipse, Parabel, Hyperbel und B-Splines wird der Prozess noch nicht unterstützt.

Hinweise

  • All coincidences are transferred - start point, end point and center point (if applicable).
  • Point on object constraint is transferred to the closer newly created edge.
  • Vertical and horizontal constraints are copied to both offsprings.
  • Parallel and perpendicular constraints are copied for both line segments, for arc only once, to the closer part.
  • Equality constraint is transferred only for resulting arc edges, line segments do not receive it.
  • Symmetry constraint is currently not transferred.
  • Block constraint is currently not transferred.
  • Horizontal, vertical and length constraints between points are transferred to the outer points of the new edges.
  • Point distance constraint is assigned only once, to the closer edge segment.
  • Radius and diameter constraints are copied to any resulting arc.
  • Angle constraint is currently not transferred