Sketcher Extend

From FreeCAD Documentation
This page contains changes which are not marked for translation.
This documentation is a work in progress. Please don't mark it as translatable since it will change in the next hours and days.

Sketcher Extend

Menu location
Sketch → Sketcher geometries → Extend edge
Workbenches
Sketcher
Default shortcut
G Q
Introduced in version
0.17
See also
Sketcher Trim edge

Description

The Sketcher Extend tool extends or shortens a line or an arc to an arbitrary location, or to a target edge or point.

Shown on the left (1), the two sketch elements before the operation; in the middle (2), the line is being extended to the arc; on the right (3), the final result.

Usage

See also: Drawing aids.

  1. There are several ways to invoke the tool:
    • Press the Sketcher Extend edge button.
    • Select the Sketcher → Sketcher geometries → Extend edge option from the menu.
    • Right-click in the 3D view and select the Extend edge option from the context menu.
    • Use the keyboard shortcut: G then Q.
  2. If there is a previous selection it is cleared. The tool does not accept a pre-selection.
  3. The cursor changes to a white cross with the tool icon.
  4. Select a line or an arc.
  5. Move the cursor in the direction to extend or shorten.
  6. Do one of the following:
    • Click an arbitrary point.
    • To extend/shorten to another edge (Auto constraints must be enabled): Place the cursor over the target edge. When it is highlighted and the Point on object constraint icon appears besides the cursor, click to confirm. The constraint is added.
    • To extend/shorten to a point (Auto constraints must be enabled): Place the cursor over the target point. when it is highlighted and the Coincident constraint icon appears besides the cursor, click to confirm. The constraint is added.
  7. If the tool runs in continue mode:
    1. Optionally keep extending/shortening edges.
    2. To finish, click in an empty area in the 3D view, right-click or press Esc, or start another geometry or constraint creation tool.

Notes

  • If not fully constrained, the target edge or point may be modified as well.