Sketcher CreatePoint/ro: Difference between revisions

From FreeCAD Documentation
(Updating to match new version of source page)
(Updating to match new version of source page)
 
(One intermediate revision by the same user not shown)
Line 3: Line 3:
{{Docnav
{{Docnav
|[[Sketcher_StopOperation|Stop operation]]
|[[Sketcher_StopOperation|Stop operation]]
|[[Sketcher_CreatePolyline|Polyline]]
|[[Sketcher_CreateLine|Line]]
|[[Sketcher_Workbench|Sketcher]]
|[[Sketcher_Workbench|Sketcher]]
|IconL=Sketcher_StopOperation.svg
|IconL=Sketcher_StopOperation.svg
|IconR=Sketcher_CreateLine.svg
|IconR=Sketcher_CreatePolyline.svg
|IconC=Workbench_Sketcher.svg
|IconC=Workbench_Sketcher.svg
}}
}}
Line 28: Line 28:
See also: [[Sketcher_Workbench#Drawing_aids|Drawing aids]].
See also: [[Sketcher_Workbench#Drawing_aids|Drawing aids]].


Pos-OVP = Positional [[Sketcher_Preferences#General|On-View-Parameters]]. {{Version|0.22}}
Pos-OVP = Positional [[Sketcher_Preferences#General|On-View-Parameters]]. {{Version|1.0}}


<div class="mw-translate-fuzzy">
<div class="mw-translate-fuzzy">
Line 43: Line 43:
{{Docnav
{{Docnav
|[[Sketcher_StopOperation|Stop operation]]
|[[Sketcher_StopOperation|Stop operation]]
|[[Sketcher_CreatePolyline|Polyline]]
|[[Sketcher_CreateLine|Line]]
|[[Sketcher_Workbench|Sketcher]]
|[[Sketcher_Workbench|Sketcher]]
|IconL=Sketcher_StopOperation.svg
|IconL=Sketcher_StopOperation.svg
|IconR=Sketcher_CreateLine.svg
|IconR=Sketcher_CreatePolyline.svg
|IconC=Workbench_Sketcher.svg
|IconC=Workbench_Sketcher.svg
}}
}}

Latest revision as of 11:02, 23 April 2024

Sketcher CreatePoint

poziția meniului
Sketch → Sketcher geometries → Create point
Ateliere
Sketcher
scurtătură
nici unul
Prezentat în versiune
-
A se vedea, de asemenea,
nici unul

Descriere

Instrumentul Point creează un punct în schița curentă, care poate fi utilizată pentru construirea de elemente geometrice. Punctul este mereu un element de construcție și nu poate fi prezentat într-o vizualizarea 3D.

Cum se folosește

See also: Drawing aids.

Pos-OVP = Positional On-View-Parameters. introduced in version 1.0

  • Click pe butonul Create point, pentru a activa funcția.
  • Click pe schiță pentru a crea un punct.
  • Apăsați Esc sau click butonul dreapta pentru a abandona funcția.

Notes

  • version 0.21 and below: Points are always created as construction geometry. Optionally change them to normal geometry with Sketcher ToggleConstruction to make them visible outside of Sketch editing mode.