Sketcher: Punto

From FreeCAD Documentation
This page is a translated version of the page Sketcher CreatePoint and the translation is 25% complete.
Outdated translations are marked like this.

Punto

Posizione nel menu
Sketch → Geometrie → Punto
Ambiente
Sketcher
Avvio veloce
Nessuno
Introdotto nella versione
-
Vedere anche
Nessuno

Descrizione

Lo strumento Punto crea un punto nello schizzo corrente, il punto può essere utilizzato per la costruzione di elementi geometrici.

Il punto è sempre un elemento di costruzione e non viene visualizzato nella vista 3D.

Utilizzo

See also: Drawing aids.

Pos-OVP = Positional On-View-Parameters. introduced in version 1.0

  • Cliccare sul pulsante Crea punto per attivare la funzione.
  • Posizionare il cursore nel punto desiderato e cliccare.
  • Premere Esc o il tasto destro del mouse per uscire dalla funzione.

Notes

  • version 0.21 and below: Points are always created as construction geometry. Optionally change them to normal geometry with Sketcher ToggleConstruction to make them visible outside of Sketch editing mode.