Sketcher NewSketch/cs: Difference between revisions

From FreeCAD Documentation
(Updating to match new version of source page)
(Updating to match new version of source page)
Line 23: Line 23:
Note that the [[PartDesign Workbench|PartDesign workbench]] has its own [[PartDesign NewSketch|new sketch]] command, when using PartDesign it is preferable to use its own dedicated tool.
Note that the [[PartDesign Workbench|PartDesign workbench]] has its own [[PartDesign NewSketch|new sketch]] command, when using PartDesign it is preferable to use its own dedicated tool.


<div class="mw-translate-fuzzy">
==Použití==
==Použití==
</div>


Clicking on the icon without a face (pre-)selected will pop up a dialog asking if the sketch should be drawn on the
Clicking on the icon without a face (pre-)selected will pop up a dialog asking if the sketch should be drawn on the
Line 37: Line 39:
The sketch can be re-mapped to another already existing face using the [[Sketcher MapSketch|Map Sketch - Command]].
The sketch can be re-mapped to another already existing face using the [[Sketcher MapSketch|Map Sketch - Command]].


The sketch can be moved in the 3D-Space using [[Placement]].
The sketch can be moved in the [[3D view]] using [[Placement]].





Revision as of 21:40, 14 February 2020

Skicář Nový náčrt

Umístění Menu
Náčrt → Vytvoř náčrt
Pracovní stoly
Skicář
Výchozí zástupce
Nikdo
Představen ve verzi
-
Viz také
Sketcher MapSketch, Sketcher Reorient

Popis

This will create a new sketch.

Note that the PartDesign workbench has its own new sketch command, when using PartDesign it is preferable to use its own dedicated tool.

Použití

Clicking on the icon without a face (pre-)selected will pop up a dialog asking if the sketch should be drawn on the

  • XY-Plane
  • XZ-Plane
  • YZ-Plane

You can change an offset to any of the three planes and the side of the offset.

Clicking on the icon with a (pre-selected) face will cause the sketch to be mapped to the selected face.

Poznámka

The sketch can be re-mapped to another already existing face using the Map Sketch - Command.

The sketch can be moved in the 3D view using Placement.