Sketcher CompCreateRectangles/de

From FreeCAD Documentation
Revision as of 14:57, 5 December 2023 by FBXL5 (talk | contribs) (Created page with "==Hinweise==")


Sketcher AuswahlRechteckErstellen

Menüeintrag
Keiner
Arbeitsbereich
Sketcher
Standardtastenkürzel
Keiner
Eingeführt in Version
0.20
Siehe auch
Keiner

Beschreibung

Rechtecke erstellen ist eine Symbolschaltfläche in der Werkzeugleiste Sketcher geometries, die Werkzeuge zur Erstellung von Rechtecken gruppiert. Klicke auf den Abwärtspfeil rechts daneben, um die Symbole darunter zu erweitern und ein Werkzeug auszuwählen.

Arten von Rechtecken

Hinweise

  1. A Mode spinbox to chose one of the modes to draw the rectangle:
    • Corner, length & width
    • Center, length & width
    • 3 corners
    • Center and two corners
  2. A Rounded corners checkbox to apply round corners to the rectangle.
  3. A Frame checkbox to add a contour with a constant offset to the (rounded) rectangle.
  • All three buttons in this selection now launch the same tool but with different preset combinations of mode and options that can still be altered after the first click.
  • If Rounded corners is enabled, the offset is inward, and the offset value is larger than the corner radius, the offset contour will be created without fillets.
  • The modes 3 corners, and Center and two corners create parallelograms rather than rectangles.