TechDraw HowTo Page: Difference between revisions

From FreeCAD Documentation
(HowTo page for TechDraw with some tips & tricks and problem solutions.)
 
Line 26: Line 26:
[[#top|top]]
[[#top|top]]


=== Change the Template File of a Drawing ===
When you have already made a drawing its possible to change the template file in the running program.

* click the desired page in the tree
*: if not already open the tree should open a small sub-tree with several leaves
* Select the Template leaf
* in the property panel/Data Tab/Template is the path to the template file. To change the file press the ellipsis button ('...'). This will open your default template folder (as set in Preferences/TechDraw).
* select another template file.
The new file will be opened directly.

When you want to update a changed template file (useful if you develop an [[TechDraw TemplateHowTo|own template file]]) note that you have to load another file before you can select the same file again. This is because the selection of the same file is ignored.

[[#top|top]]


</translate>
</translate>

Revision as of 21:40, 26 July 2020

Back to TechDraw Tutorials

Introduction

This page provide a collection of hints and little guides on using the TechDraw Workbench. Adding new findings and best practices is encouraged.

top

Enable/Disable Centermarks

When the centermarks are disabled hole centers and similar things can not be dimensioned. The centermarks are redndered as a little cross.

  • Select the view port (e.g. "Front")
  • In the property panel, 'View Tab set the value Arc Center Marks to true

Note in this tab are other settings for the view that might be useful.

top

Keyboard shortcuts for Dimensions

Unlike the sketcher workbench, the TechDraw Workbench of FreeCAD 0.18 has not yet keyboard shortcuts for adding dimensions. Use the mouse to select the buttons in the tool bar. For FreeCAD 0.19 there is a discussion to add this.

top

Change the Template File of a Drawing

When you have already made a drawing its possible to change the template file in the running program.

  • click the desired page in the tree
    if not already open the tree should open a small sub-tree with several leaves
  • Select the Template leaf
  • in the property panel/Data Tab/Template is the path to the template file. To change the file press the ellipsis button ('...'). This will open your default template folder (as set in Preferences/TechDraw).
  • select another template file.

The new file will be opened directly.

When you want to update a changed template file (useful if you develop an own template file) note that you have to load another file before you can select the same file again. This is because the selection of the same file is ignored.

top


Template:Tutorials navi