Draft Pattern: Difference between revisions

From FreeCAD Documentation
(Usage...)
No edit summary
Line 34: Line 34:
# Select the objects.
# Select the objects.
# Switch to the {{MenuCommand|View}} tab of the [[Property_editor|Property editor]].
# Switch to the {{MenuCommand|View}} tab of the [[Property_editor|Property editor]].
# The {{PropertyView|Display Mode}} property of the objects must be set to {{Value|Flat Lines}}.
# The {{PropertyView|Display Mode}} of the objects must be set to {{Value|Flat Lines}}.
# Select a {{PropertyView|Pattern}}.
# Select a {{PropertyView|Pattern}}.
# Optionally change the {{PropertyView|Pattern Size}}. Note that a higher value results in a denser hatch pattern.
# Optionally change the {{PropertyView|Pattern Size}}. Note that a higher value results in a denser hatch pattern.

Revision as of 07:52, 12 August 2021

This documentation is a work in progress. Please don't mark it as translatable since it will change in the next hours and days.

Description

Draft objects with a DataMake Face property can display a hatch pattern instead of a solid face color.

Usage

See also: Property editor.

  1. Make sure the objects are closed and planar and do not self-intersect.
  2. To close a Draft Wire, a Draft BSpline, a Draft CubicBezCurve or a Draft BezCurve set its DataClosed property to true.
  3. To close a Draft Circle or a Draft Ellipse set its DataFirst Angle and DataLast Angle properties to the same value.
  4. Select the objects.
  5. Switch to the View tab of the Property editor.
  6. The ViewDisplay Mode of the objects must be set to Flat Lines.
  7. Select a ViewPattern.
  8. Optionally change the ViewPattern Size. Note that a higher value results in a denser hatch pattern.
  9. The hatch pattern is not displayed when the objects are selected. Deselect them to check the result.
  10. Optionally reselect the objects to change the pattern properties.

Available patterns