Окружность
Part Circle |
Системное название |
---|
Part Circle |
Расположение в меню |
Деталь → Создать примитивы... → Circle |
Верстаки |
Part |
Быстрые клавиши |
Нет |
Представлено в версии |
- |
См. также |
Нет |
Description
This command will create a circular curved edge. With the default values, the circular curved edge will be closed and therefore will be a circle. If the properties Angle 0 or Angle 1 are changed from their default values (0 and 360) the edge will be an open curve, an arc.
Alternatively a Part Circle can be initially defined from three points. Once created the circle will only contain the standard Part Circle properties and will no longer contain a reference to the creation points.
Usage
A Circle geometric primitive is available from the Create Primitives dialogue in the Part workbench.
- Switch to the Part
- There are several ways to access the Create Primitives dialogue:
- Press the Primitives button located in the Part toolbar
- Use the Part → Create primitives → Circle
Properties
- Radius: the radius of the curved edge (arc or circle)
- Angle 0: start of the curved edge, (degrees anti-clockwise), the default value is 0
- Angle 1: end of the curved edge, (degrees anti-clockwise), the default value is 360
Part
- Примитивы: Куб(Параллелограмм), Конус, Цилиндр, Сфера, Тор, Полый цилиндр,Примитивы, Связующие формы
- Создание и правка: Выдавливание, Построение фигуры вращения, Отражение, Скругление, Фаска, Создать плоскость из граней, Ruled Surface, Профиль, Sweep, Section, Cross sections, 3D Offset, 2D Offset, Создать полый объект, Projection on surface, Прикрепление
- Булевы операции: Соединить, Разорвать связь, Compound Filter, Булевы операции, Cut, Fuse, Common, Connect, Embed, Cutout, Boolean fragments, Slice apart, Slice, XOR
- Измерительные: Measure Linear, Measure Angular, Measure Refresh, Clear All, Toggle All, Toggle 3D, Toggle Delta
Документация пользователя
- Начинающим
- Установка: Загрузка, Windows, Linux, Mac, Дополнительных компонентов, Docker, AppImage, Ubuntu Snap
- Базовая: О FreeCAD, Интерфейс, Навигация мыши, Методы выделения, Имя объекта, Настройки, Верстаки, Структура документа, Свойства, Помоги FreeCAD, Пожертвования
- Помощь: Учебники, Видео учебники
- Верстаки: Std Base, Arch, Assembly, CAM, Draft, FEM, Inspection, Mesh, OpenSCAD, Part, PartDesign, Points, Reverse Engineering, Robot, Sketcher, Spreadsheet, Surface, TechDraw, Test Framework