Sketcher NewSketch/es: Difference between revisions

From FreeCAD Documentation
(Created page with "Tenga en cuenta que la 24px Ambiente de trabajo DiseñoPiezas tiene su propia herramienta PartDesign_NewSketch...")
(Created page with "Al hacer clic en el icono sin una cara (pre)seleccionada, aparecerá un cuadro de diálogo en el que se pregunta si el croquis debe dibujarse en el * Plano XY * Plano XZ * Pla...")
Line 25: Line 25:
==Utilización==
==Utilización==


Al hacer clic en el icono sin una cara (pre)seleccionada, aparecerá un cuadro de diálogo en el que se pregunta si el croquis debe dibujarse en el
Clicking on the icon without a face (pre-)selected will pop up a dialog asking if the sketch should be drawn on the
* XY-Plane
* Plano XY
* XZ-Plane
* Plano XZ
* YZ-Plane
* Plano YZ
Puede cambiar un desplazamiento a cualquiera de los tres planos y el lado del relleno.
You can change an offset to any of the three planes and the side of the offset.


Clicking on the icon with a (pre-selected) face will cause the sketch to be mapped to the selected face.
Clicking on the icon with a (pre-selected) face will cause the sketch to be mapped to the selected face.

Revision as of 20:33, 4 July 2021

Croquizador Nuevo croquis

Ubicación en el Menú
Croquis → Crear croquis
Entornos de trabajo
Croquizador
Atajo de teclado por defecto
Ninguno
Introducido en versión
-
Ver también
DiseñoPieza Nuevo croquis, Croquizador MapearCroquis, Croquizador Reorientar

Descripción

Esto creará un nuevo Croquis.

Tenga en cuenta que la Ambiente de trabajo DiseñoPiezas tiene su propia herramienta nuevo croquis, cuando se trabaja en un Cuerpo DiseñoPiezas es preferible utilizar esa herramienta.

Utilización

Al hacer clic en el icono sin una cara (pre)seleccionada, aparecerá un cuadro de diálogo en el que se pregunta si el croquis debe dibujarse en el

  • Plano XY
  • Plano XZ
  • Plano YZ

Puede cambiar un desplazamiento a cualquiera de los tres planos y el lado del relleno.

Clicking on the icon with a (pre-selected) face will cause the sketch to be mapped to the selected face.

Notas

The sketch can be re-mapped to another already existing face using the Map Sketch - Command.

The sketch can be moved in the 3D view using Placement.