Croquizador RestringirVertical

From FreeCAD Documentation
This page is a translated version of the page Sketcher ConstrainVertical and the translation is 13% complete.
Outdated translations are marked like this.

Restricción de verticalidad

Ubicación en el Menú
Sketch → Restricciones de croquis → Restricción de verticalidad
Entornos de trabajo
Sketch
Atajo de teclado por defecto
V
Introducido en versión
-
Ver también
Restringir horizontalmente

Descripción

The Sketcher ConstrainVertical tool constrains lines or pairs of points to be vertical (parallel to the vertical axis of the sketch).

introduced in version 1.0: In most cases it is advisable to use the combined Sketcher ConstrainHorVer tool instead.

Utilización

See also: Drawing aids.

Continue mode

  1. Make sure there is no selection.
  2. There are several ways to invoke the tool:
    • introduced in version 1.0: If the Auto tool for Horizontal/Vertical preference is selected (default): press the down arrow to the right of the button and select the Constrain vertical option from the dropdown.
    • If this preference is not selected (and in version 0.21 and below): press the Constrain vertical button.
    • Select the Sketch → Sketcher constraints → Constrain vertical option from the menu.
    • Use the keyboard shortcut: V.
  3. For further steps see Sketcher ConstrainHorizontal.

Run-once mode

See Sketcher ConstrainHorizontal.

Scripting

See Sketcher ConstraintHorizontal.