Sketcher CreateSlot/it: Difference between revisions

From FreeCAD Documentation
(Updating to match new version of source page)
(Updating to match new version of source page)
 
Line 27: Line 27:
See also: [[Sketcher_Workbench#Drawing_aids|Drawing aids]].
See also: [[Sketcher_Workbench#Drawing_aids|Drawing aids]].


Pos-OVP = Positional [[Sketcher_Preferences#General|On-View-Parameters]]. {{Version|0.22}}<br>
Pos-OVP = Positional [[Sketcher_Preferences#General|On-View-Parameters]]. {{Version|1.0}}<br>
Dim-OVP = Dimensional On-View-Parameters. {{Version|0.22}}
Dim-OVP = Dimensional On-View-Parameters. {{Version|1.0}}


<div class="mw-translate-fuzzy">
<div class="mw-translate-fuzzy">
Line 40: Line 40:


* {{VersionMinus|0.21}} ({{Version|0.20}}): Holding {{KEY|Ctrl}} when picking the second center will constrain the slot to be drawn horizontally or vertically.
* {{VersionMinus|0.21}} ({{Version|0.20}}): Holding {{KEY|Ctrl}} when picking the second center will constrain the slot to be drawn horizontally or vertically.
* {{Version|0.22}}: [[Sketcher_Snap|Angular snap]] can be used to control the angle of the slot.
* {{Version|1.0}}: [[Sketcher_Snap|Angular snap]] can be used to control the angle of the slot.
* {{Version|0.20}}: A slot can also be constrained horizontally or vertically if the [[Sketcher_Workbench#Auto_constraints|Auto constraints]] option is enabled.
* {{Version|0.20}}: A slot can also be constrained horizontally or vertically if the [[Sketcher_Workbench#Auto_constraints|Auto constraints]] option is enabled.



Latest revision as of 10:09, 21 April 2024

Crea asola

Posizione nel menu
Sketch → Geometrie → Asola
Ambiente
Sketcher
Avvio veloce
Nessuno
Introdotto nella versione
-
Vedere anche
Nessuno

Descrizione

Disegna un'asola selezionando il centro di un semicerchio e un punto finale dell'altro semicerchio.

Quando si avvia lo strumento, il puntatore del mouse si trasforma in una croce bianca con l'icona di un'asola rossa.

Le coordinate del puntatore sono riportate accanto, in blu e in tempo reale.

Utilizzo

See also: Drawing aids.

Pos-OVP = Positional On-View-Parameters. introduced in version 1.0
Dim-OVP = Dimensional On-View-Parameters. introduced in version 1.0

  • Premere il pulsante Crea asola,
  • Cliccare un punto per definire il centro di uno dei semicerchi,
  • Muovere il mouse e cliccare per stabilire un punto finale del semicerchio opposto.
  • Premere Esc o cliccare sul tasto destro del nouse per uscire dalla funzione.

Notes