Sketcher "Прямоугольник"

From FreeCAD Documentation
Revision as of 12:57, 2 January 2024 by FuzzyBot (talk | contribs) (Updating to match new version of source page)

Создать прямоугольник

Системное название
Sketcher_CreateRectangle
Расположение в меню
Sketch → Геометрия эскиза → Создать прямоугольник
Верстаки
Sketcher
Быстрые клавиши
R
Представлено в версии
-
См. также
Создать скругленный прямоугольник, Создать полилинию

Описание

Этот инструмент рисует прямоугольник, по двум противоположным точкам. При запуске инструмента указатель мыши меняется на белый крест с красным прямоугольником. Координаты указателя отображаются рядом с ним синим цветом в режиме реального времени.

To define a rectangle via a center point and an edge point, use the Centered rectangle tool.

Применение

  • После нажатия кнопки Прямоугольник щелкните один раз, чтобы установить первый угол, затем переместите мышь и щелкните второй раз, чтобы установить противоположный угол.
  • Нажатие Esc или правой кнопки мыши закрывает функцию.

Notes

  1. A Mode spinbox to chose one of the modes to draw the rectangle:
    • Corner, length & width
    • Center, length & width
    • 3 corners
    • Center and two corners
  2. A Rounded corners checkbox to apply round corners to the rectangle.
  3. A Frame checkbox to add a contour with a constant offset to the (rounded) rectangle.
  • All three buttons in this selection now launch the same tool but with different preset combinations of mode and options that can still be altered after the first click.
  • If Rounded corners is enabled, the offset is inward, and the offset value is larger than the corner radius, the offset contour will be created without fillets.
  • The modes 3 corners, and Center and two corners create parallelograms rather than rectangles.