Sketcher Congé

From FreeCAD Documentation
Revision as of 13:55, 14 April 2024 by David69 (talk | contribs)

Sketcher Congé

Emplacement du menu
Esquisse → Géométries d'esquisse → Créer un congé
Ateliers
Sketcher
Raccourci par défaut
G F F
Introduit dans la version
-
Voir aussi
Aucun

Description

Cet outil crée un congé entre deux lignes.

introduced in version 0.22: If two straight edges connected by a Coincident constraint are filleted or chamfered, the corner point can optionally be preserved by adding a Point object that has a Point on object constraint with both edges. Constraints connected to the corner point are then transferred to the new point object.

Utilisation

See also: Drawing aids.

  1. Appuyez sur le bouton Congé d'esquisse.
  2. Choisissez un sommet reliant deux lignes non parallèles, ou choisissez deux lignes qui ne sont pas parallèles.
  3. Si un sommet est sélectionné, le rayon du congé est dérivé de la longueur de la ligne la plus courte. Si deux lignes sont sélectionnées, le rayon est la distance entre le premier point cliqué et l'intersection (étendue) des lignes.
  4. Appuyez sur Echap ou cliquez sur le bouton droit de la souris annule ou termine la fonction.

Notes

  • The construction geometry arc of a chamfer is not visible outside the sketch. It cannot be deleted without breaking the geometry of the chamfer.
  • Some (conic) curves may need to be trimmed before they can be filleted.
  • The fillet radius depends on the selection method. If a Coincident constraint connecting two straight edges is selected, the fillet radius is derived from the length of the shortest edge. If two edges are selected the radius is the distance from the first clicked point to the (extended) intersection of the edges.