Sketcher ConstrainSymmetric/ru: Difference between revisions

From FreeCAD Documentation
(Updating to match new version of source page)
No edit summary
Line 48: Line 48:
See the tracker [https://freecadweb.org/tracker/view.php?id=4144 issue #4144], and [https://forum.freecadweb.org/viewtopic.php?f=3&t=39611 forum thread].
See the tracker [https://freecadweb.org/tracker/view.php?id=4144 issue #4144], and [https://forum.freecadweb.org/viewtopic.php?f=3&t=39611 forum thread].


{{Docnav/ru
<div class="mw-translate-fuzzy">
{{Docnav/ru|[[Sketcher_ConstrainEqual/ru|Equal Length]]|
|[[Sketcher_ConstrainEqual/ru|Equal Length]]
[[Sketcher_ConstrainBlock/ru|Constrain Block]]|[[Sketcher_Workbench/ru|Sketcher]]|IconL=Constraint_EqualLength.png|IconC=Workbench_Sketcher.svg|IconR=Sketcher_ConstrainBlock.png}}
|[[Sketcher_ConstrainBlock/ru|Constrain Block]]
|[[Sketcher_Workbench/ru|Sketcher]]
</div>
|IconL=Constraint_EqualLength.svg
|IconR=Sketcher_ConstrainBlock.svg
|IconC=Workbench_Sketcher.svg
}}


{{Sketcher Tools navi{{#translation:}}}}
{{Sketcher Tools navi{{#translation:}}}}

Revision as of 16:45, 14 December 2020

Sketcher ConstrainSymmetric

Системное название
Sketcher ConstrainSymmetric
Расположение в меню
Sketch → Ограничения эскиза → Ограничение симметричности
Верстаки
Sketcher
Быстрые клавиши
S
Представлено в версии
-
См. также
Ограничение параллельности

Описание

Ограничение симметричности требует от двух выделенных точек быть симметричными относительно данной линии, то есть от обеих точек требуется лежать на нормали к линии через обе точки на одинаковом расстоянии от линии. Альтернативно, она может наложить ограничение на две точки быть симметричными относительно третьей.

Использование

Выделите в эскизе две точки (вершины) и линию. Выделенные точки и линия станут тёмно-зелёными.

Кликните на иконке SymmetricalConstraint на панели инструментов Sketcher или выделите меню Constrain Symmetrical в субменю Sketcher Constraints в разделе меню Sketcher (или Part Design).

Это назначит ограничения для выделенных элементов.

Note: if you want to define a symmetry constraint with respect to a point, the order of the selection is important, depending on if you select the tool at the beginning or at the end.

  • If you click the tool first: select the first point, then the symmetry reference point, and finally the second point.
  • If you click the tool last: select the first point, then the second point, and finally the symmetry reference point.

See the tracker issue #4144, and forum thread.