Sketcher ConstrainSymmetric/ru: Difference between revisions

From FreeCAD Documentation
(Replaced content with "==Использование==")
(Created page with "Выделите в эскизе две точки (вершины) и линию. Выделенные точки и линия станут тёмно-зелёными.")
Line 26: Line 26:
[[File:SymmetricConstraint1.png|256px]]
[[File:SymmetricConstraint1.png|256px]]


Выделите в эскизе две точки (вершины) и линию. Выделенные точки и линия станут тёмно-зелёными.
Select two points (vertexes) in the sketch and a line in the sketch. The selected points and the line will be dark green.


[[File:SymmetricConstraint2.png|256px]]
[[File:SymmetricConstraint2.png|256px]]

Revision as of 09:52, 17 May 2020

Sketcher ConstrainSymmetric

Системное название
Sketcher ConstrainSymmetric
Расположение в меню
Sketch → Ограничения эскиза → Ограничение симметричности
Верстаки
Sketcher
Быстрые клавиши
S
Представлено в версии
-
См. также
Ограничение параллельности

Описание

Ограничение симметричности требует от двух выделенных точек быть симметричными относительно данной линии, то есть от обеих точек требуется лежать на нормали к линии через обе точки на одинаковом расстоянии от линии. Альтернативно, она может наложить ограничение на две точки быть симметричными относительно третьей.

Использование

Выделите в эскизе две точки (вершины) и линию. Выделенные точки и линия станут тёмно-зелёными.

Click on the SymmetricalConstraint icon in the Sketcher toolbar or select the Constrain Symmetrical menu item from the Sketcher Constraints sub menu of the Sketcher (or Part Design) menu item.

This will apply the constraint to the selected items.

Note: if you want to define a symmetry constraint with respect to a point, the order of the selection is important, depending on if you select the tool at the beginning or at the end.

  • If you click the tool first: select the first point, then the symmetry reference point, and finally the second point.
  • If you click the tool last: select the first point, then the second point, and finally the symmetry reference point.

See the tracker issue #4144, and forum thread.