Croquizador CrearArcoDeHipérbola

From FreeCAD Documentation
Revision as of 22:27, 1 July 2021 by Maker (talk | contribs) (Created page with "{{Docnav/es |Arco de elipse |Arco de parábola |Croquizador |IconL=Sketcher_Cr...")

Sketcher arco de hipérbola

Ubicación en el Menú
Sketch → Geometrías de croquis → Crear un arco de hipérbola
Entornos de trabajo
Sketcher
Atajo de teclado por defecto
Ninguno
Introducido en versión
0.17
Ver también
Sketcher arco de elipse, Sketcher arco de parábola

Descripción

Esta herramienta crea un arco de hipérbola por centro, radio mayor y puntos finales.

Utilización

  1. Press the Arc of Hyperbola button.
  2. Click in the 3D view to define the major radius center (labelled 1 in the picture above).
  3. Click in the 3D view to define the major radius length, which is also the tip of the arc of hyperbola (labelled 2 in the picture above).
  4. Move the mouse away from the two last selected points to see how the arc will look like. Click again when the approximate desired curvature is shown. This point will define the first end point (labelled 3 in the picture above).
  5. Click a fourth time in the 3D view to define the other end point (labelled 4 in the picture above).