Draft Rectangle/ru

From FreeCAD Documentation
Revision as of 10:57, 2 November 2018 by FuzzyBot (talk | contribs) (Updating to match new version of source page)

Draft Rectangle

Системное название
Draft Rectangle
Расположение в меню
Черчение -> Прямоугольник
Верстаки
Draft, Arch
Быстрые клавиши
R E
Представлено в версии
-
См. также
Куб

Description

The Rectangle tool creates a rectangle by picking two points. It uses the Draft Linestyle set on the Draft tray toolbar. You can optionally add a 45 degree chamfer or circular fillet to every corner of the rectangle, and you can divide the rectangle into a series of equal-sized rows and/or columns.

How to use

  1. Press the Draft Rectangle button, or press R then E keys
  2. Click a first corner point on the 3D view, or type a coordinate
  3. Click another opposite point on the 3D view, or type a coordinate. The rectangle will also be a face, even if it appears as wireframe.

Options

  • Press X, Y or Z after a point to constrain the next point on the given axis.
  • To enter coordinates manually, simply enter the numbers, then press ENTER between each X, Y and Z component.
  • Press R or click the checkbox to check/uncheck the Relative button. If relative mode is on, the coordinates of the next point are relative to the last one. If not, they are absolute, taken from the (0,0,0) origin point.
  • Press T or click the checkbox to check/uncheck the Continue button. If continue mode is on, the Rectangle tool will restart after you finish or close it, allowing you to draw another one without pressing the Rectangle button again.
  • Press CTRL while drawing to force snapping your point to the nearest snap location, independently of the distance.
  • Press SHIFT while drawing to constrain your next point horizontally or vertically in relation to the last one.
  • Press I or the Filled button to have the rectangle filled with a face after it has been closed.
  • Press ESC or the Cancel button to abort the current Line command.
  • Rectangles, when in "Flat Lines" display mode, can display a hatch pattern, by setting their "Pattern" property.

Properties

  • ДанныеLength: Specifies the length of the rectangle
  • ДанныеWidth: Specifies the width of the rectangle
  • ДанныеChamfer Size: Specifies the diagonal size of the 45 degree chamfer at each corner of the rectangle
  • ДанныеFillet Radius: Specifies the radius of the 90 degree fillet at each corner of the rectangle
  • ДанныеRows: Divides the rectangle (horizontally) into equal-sized rows. The whole rectangle is 1 row, by default
  • ДанныеColumns: Divides the rectangle (vertically) into equal-sized columns. The whole rectangle is 1 column, by default
  • ДанныеMake Face: Fills the rectangle with a face
  • ВидTexture Image: Allows to give the path to an image file to be mapped on the rectangle. It is up to you to give the rectangle the same proportion as the image if you want to avoid distortions. Blanking this property will remove the image.
  • ВидPattern: Specifies a hatch pattern to fill the wire with.
  • ВидPattern Size: Specifies the size of the hatch pattern

See also Draft Pattern page.

Scripting

The Rectangle tool can be used in macros and from the Python console by using the following function:

Rectangle = makeRectangle(length, height, placement=None, face=None, support=None)
  • Creates a Rectangle object with length in X direction and height in Y direction.
  • If a placement is given, it is used.
  • If face is None, the rectangle is shown as a wireframe, otherwise as a face.
  • The current Draft Linestyle will be used.

Example:

import FreeCAD, Draft

Rectangle = Draft.makeRectangle(10, 4)