Sketcher CreatePolyline/cs: Difference between revisions
Renatorivo (talk | contribs) (Created page with "Tento nástroj funguje podobně jako Skicář Přímka, ale vytváří postupně přímkové segmenty, které jsou spojeny v jejich vrcholech. Při spuš...") |
Renatorivo (talk | contribs) No edit summary |
||
Line 5: | Line 5: | ||
==Popis== |
==Popis== |
||
Tento nástroj funguje podobně jako |
Tento nástroj funguje podobně jako [[Sketcher Line/cs|Skicář Přímka]], ale vytváří postupně přímkové segmenty, které jsou spojeny v jejich vrcholech. |
||
Při spuštění nástroje se ukazatel myši změní na bílý křížek s červenou ikonou lomené čáry. |
Při spuštění nástroje se ukazatel myši změní na bílý křížek s červenou ikonou lomené čáry. |
||
Souřadnice ukazatele jsou vedle zobrazovány v reálném čase. |
Souřadnice ukazatele jsou vedle zobrazovány v reálném čase. |
Revision as of 22:27, 3 November 2018
Skicář Lomená čára |
Umístění Menu |
---|
Náčrt → Skicář Konstrukce → Vytvořit Lomenou čáru |
Pracovní stoly |
Skicář |
Výchozí zástupce |
Nikdo |
Představen ve verzi |
- |
Viz také |
Skicář Přímka |
Popis
Tento nástroj funguje podobně jako Skicář Přímka, ale vytváří postupně přímkové segmenty, které jsou spojeny v jejich vrcholech. Při spuštění nástroje se ukazatel myši změní na bílý křížek s červenou ikonou lomené čáry. Souřadnice ukazatele jsou vedle zobrazovány v reálném čase.
Polyline started with a line, a tangent arc, a perpendicular arc then a tangent line
How to use
The polyline always starts with a straight line segment: click - move the mouse - click. Move the mouse again. After placing the first line segment, the Sketcher polyline tool has multiple modes that can be toggled with the M key. For example you can draw tangent or perpendicular arcs following a line or arc segment. Repeatedly pressing the M key toggles through these different modes:
- Press the M key: the new segment is a line which is perpendicular to the previous segment.
- Press the M key again: the new segment is a line which is tangential to the previous segment.
- Press the M key again: the new segment is an arc which is tangential to the previous segment.
- Press the M key again: the new segment is an arc which is perpendicular (left) to the previous segment.
- Press the M key again: the new segment is an arc which is perpendicular(right) to the previous segment.
- Press the M key again: You are again in the state where you started; the line is only connected with a coincidence to the previous segment.
- v0.18 and above While in any of the arc modes, holding down the Ctrl key (MacOS: CMD key) and moving the cursor causes the arc to snap by increments of 45 degrees, relative to the previously created polyline segment.
- Pick points on an empty area of the 3D view, or on an existing object (auto constraints must be active in TaskView).
- Pressing Esc or clicking the right mouse button before closing the polyline to a loop ends the current polyline and you can continue with a new one. Pressing Esc or clicking the right mouse button again ends the polyline function.
- Pressing Esc or clicking the right mouse button after closing the polyline to a loop ends the polyline function.