Sketcher: Punto

From FreeCAD Documentation
Revision as of 21:17, 3 November 2018 by Renatorivo (talk | contribs) (Created page with "== Opzioni ==")

Punto

Posizione nel menu
Sketch → Geometrie → Punto
Ambiente
Sketcher
Avvio veloce
Nessuno
Introdotto nella versione
-
Vedere anche
Nessuno

Descrizione

Lo strumento Punto crea un punto nello schizzo corrente, il punto può essere utilizzato per la costruzione di elementi geometrici.

Il punto è sempre un elemento di costruzione e non viene visualizzato nella vista 3D.

Point in the sketcher

Utilizzo

  • Cliccare sul pulsante Crea punto per attivare la funzione.
  • Posizionare il cursore nel punto desiderato e cliccare.
  • Premere Template:KEY/it o il tasto destro del mouse per uscire dalla funzione.

Opzioni

A mode to snap to the grid can be set in the Sketcher Preferences. The point snaps then to the grid, if it has less than 25% grid distance to a grid line. The snap mode does not fix them to the grid. The points can be moved with the mouse or constraints to other locations.

Limitations

The created point is not available outside of the sketch. In case a point is needed in the 3D-view, use the PartDesign Point for a datum point or the Part Point instead.