PartDesign Toro Sustractivo

From FreeCAD Documentation
Revision as of 16:20, 2 June 2021 by Stylishcp (talk | contribs) (Created page with "# Presionar el botón {{KEY|24px '''Toro Sustractivo'''}} . '''Nota''': El Toro sustractivo forma parte de un icono de herramientas l...")

PartDesign Toro Sustractivo

Ubicación en el Menú
Part Design → Crear una primitiva sustractiva → Toro Sustractivo
Entornos de trabajo
PartDesign
Atajo de teclado por defecto
Ninguno
Introducido en versión
0.17
Ver también
Ninguno

Descripción

Inserta un Toro sustractivo en el Body (cuerpo) activo. Su forma es sustraída del sólido existente.

A la izquierda: Body activo (A) mostrado en color gris y el Toro sustractivo (B) mostrado en color rojo transparente. El resultado se puede apreciar a la derecha.

Uso

  1. Presionar el botón Toro Sustractivo . Nota: El Toro sustractivo forma parte de un icono de herramientas llamado Crear una primitiva sustractiva. Tras abrir FreeCAD, la Caja sustractiva es la única mostrada en la barra de herramientas. Para obtener el Toro, pinchar en la flecha que indica hacia abajo que está al lado del icono visible y seleccionar Toro sustractivo en el menú desplegable.
  2. Seleccionar los parámetros de la primitiva y el Attachment.
  3. Aceptar OK.
  4. Una operación de Toro aparece dentro del Body(cuerpo) activo.

Options

The Torus can be edited after its creation in two ways:

  • Double-clicking it in the Model tree, or by right-clicking and selecting Edit primitive in the contextual menu; this brings up the Primitive parameters.
  • Via the Property editor.

Properties

  • DatosAttachment: defines the attachment mode as well as the Attachment Offset. See Part Attachment.
  • DatosLabel: Label given to the Torus object. Change to suit your needs.
  • DatosRadius1: Radius of the imaginary orbit around which the circular cross-section revolves. (The distance between the center of the torus and the center of the revolving cross section)
  • DatosRadius2: Radius of the circular cross-section defining the form of the torus.
  • DatosAngle1: (labelled V parameter in the Primitive parameters) lower truncation of the torus, parallel to the circular cross section (-180° in a full torus). A bug in the sources causes unexpected results at changing Angle1.
  • DatosAngle2: (unlabelled in the Primitive parameters) upper truncation of the ellipsoid, parallel to the circular cross section (180° in a full torus). A bug in the sources causes unexpected results at changing Angle2.
  • DatosAngle3: (labelled U parameter in the Primitive parameters) angle of rotation of the circular cross section (360° in a full torus).