DiseñoPiezas ElipsoideAditivo

From FreeCAD Documentation
Revision as of 11:42, 4 June 2021 by Stylishcp (talk | contribs) (Created page with "# Presionar el botón {{KEY|24px '''Elipsoide aditivo'''}} . '''Nota''': El Elipsoide aditivo forma parte de un icono de herramienta...")

Part Design Elipsoide aditivo

Ubicación en el Menú
Part Design → Crear una primitiva aditiva → Elipsoide aditivo
Entornos de trabajo
Part Design
Atajo de teclado por defecto
Ninguno
Introducido en versión
0.17
Ver también
Part Design Crear una Primitiva aditiva

Descripción

Inserta un Elipsoide aditivo en el Body (cuerpo) activo como primera operación, o lo fusiona con la operación u operaciones existentes.

Uso

  1. Presionar el botón Elipsoide aditivo . Nota: El Elipsoide aditivo forma parte de un icono de herramientas llamado Crear una primitiva aditiva. Tras abrir Freecad, el Cubo aditivo es la única primitiva mostrada en la barra de herramientas. Para obtener el botón del Elipsoide, pinchar en la flecha que indica hacia abajo, que está al lado del icono visible y seleccionar Elipsoide aditivo en el menú desplegable.
  2. Seleccionar los parámetros de la primitiva y Attachment.
  3. Aceptar OK.
  4. Una operación de Elipsoide aparece dentro del Body (cuerpo) activo.

Opciones

The Ellipsoid can be edited after its creation in two ways:

  • Double-clicking it in the Model tree, or by right-clicking and selecting Edit primitive in the contextual menu; this brings up the Primitive parameters.
  • Via the Property editor.

Propiedades

  • DatosAttachment: defines the attachment mode as well as the Attachment Offset. See Part Attachment.
  • DatosLabel: label given to the Ellipsoid object. Change to suit your needs.
  • DatosRadius1: the radius value along the ellipsoid's vertical axis; by default, parallel to the Z-axis.
  • DatosRadius2: the radius value along the ellipsoid's length; by default, parallel to the X-axis.
  • DatosRadius3: the radius value along the ellipsoid's width; by default, parallel to the Y-axis. At the default value of zero, the ellipsoid forms an oblate spheroid. This has the same form as if Radius3 is identical to Radius2.
  • DatosAngle1: (labelled V parameter in the Primitive parameters) lower truncation of the ellipsoid, parallel to the circular cross section (-90 degrees in a full spheroid)
  • DatosAngle2: (unlabelled in the Primitive parameters) upper truncation of the ellipsoid, parallel to the circular cross section (90 degrees in a full spheroid).
  • DatosAngle3: (labelled U parameter in the Primitive parameters) angle of rotation of the elliptical cross section (360 degrees in a full spheroid).