Sketcher: Vincolo Coincidenza di punti

From FreeCAD Documentation
Revision as of 21:06, 18 December 2013 by Renatorivo (talk | contribs) (Created page with "Crea un vincolo di Coincidenza di punti sull'elemento selezionato Questo strumento di vincolo richiede e accetta come argomento due punti e serve per rendere i due punti ''co...")

Coincidenza

Posizione nel menu
PartDesign → Schizzo → Coincidenza
Ambiente
Schizzo, PartDesign
Avvio veloce
Nessuno
Introdotto nella versione
-
Vedere anche
Blocca, Punto su oggetto

Crea un vincolo di Coincidenza di punti sull'elemento selezionato

Questo strumento di vincolo richiede e accetta come argomento due punti e serve per rendere i due punti coincidenti. (Nel senso di trasformarli in un unico punto.)

Nella pratica è utile quando un profilo è interrotto - per esempio dove due punti di finelinea sono uno accanto all'altro, ma le linee devono essere unite. In questo caso, un vincolo di coincidenza sui rispettivi punti finali chiude la breccia.

Usage

As stated above, this tool takes two arguments - both are points.

  1. Firstly it is necessary to highlight two distinct points. (Note this will not work if, for example, you attempt to select the start and end point of the same line).
  2. Highlighting of a drawing item is achieved by moving the mouse over the item and clicking the left-mouse-button.
  3. A highlighted item will change colour to green.
  4. Subsequent items can be highlighted by repeating the above procedure(s) NOTE: There is no-need to hold-down any special key like Ctrl to achieve multiple item selection in a drawing.
  5. Once you have two points highlighted, left-clicking on the 'PointOnPoint' constraint will cause the two points to become coincident and be replaced by a single point.

NOTE: In order to make two points coincident, FreeCAD must necessarily move one, or both, of the original points.