Díl Koule
Díl Koule |
Umístění Menu |
---|
Díl -> Koule |
Pracovní stoly |
Modul Díl, Kompletace |
Výchozí zástupce |
Nikdo |
Představen ve verzi |
- |
Viz také |
Díl Vytváření zákl.geom.tvarů |
Vytvoří jednoduchou parametrickou kouli podle parametrů pozice, úhel1, úhel2, úhel3 a poloměr.
Použití
V pracovní ploše Díl klikněte na ikonu koule . Koule bude při vytvoření umístěna do počátečního bodu (bod 0,0,0). Parametry úhly dovolují vytvořit částečnou kouli místo celé koule (defaultně jsou nastaveny na 360°)
Volby
The parametric sphere is defined by the following parameters:
- Radius
- Angle 1
- Angle 2
- Angle 3
- as well as the standard set of placement parameters
The picture below gives an overview of a parametric sphere with parameters different from the default value.
Parameter
- Radius: Radius of the sphere
- Angle 1: Angle defined between the y-axis (green arrow) and an imaginary rotating line around the x-axis (red arrow). One end of the line is fixed on the origin. The other end of the line may rotate as said around the x-axis and remain in the XY-plane. The line has the length of the radius of the sphere.
- Angle 2: Test