SheetMetal Exemples
Cette documentation n'est pas terminée. Merci de nous aider et de contribuer à la documentation.
Modèle GuiCommand explique comment les commandes doivent être documentées. Parcourez Category:UnfinishedDocu pour voir d'autres pages incomplètes comme celle-ci. Voir Category:Command_Reference pour toutes les commandes.
Voir Écrire une page Wiki pour apprendre à éditer les pages du wiki, et aller à Contribuer à FreeCAD pour apprendre d'autres façons de contribuer.Introduction
L'atelier SheetMetal est devenu très puissant et exige une documentation appropriée.
Pour éviter de surcharger les pages d'outils avec des exemples, cette page a été ajoutée pour rassembler les pièces montrant et expliquant les caractéristiques spéciales de SheetMetal.
Phases planifiées pour générer du contenu :
- Collecte d'images
- Ajout de descriptions de flux de travail
- Ajout de tutoriels plus détaillés
Hinge
Workflow Hinge:
Make Base Wall,
PartDesign Pocket,
PartDesign Hole,
Unfold.
Paper Clip
Workflow Paper Clip:
Make Base Wall,
Sketch on Sheet,
clone, flip and fuse,
Unfold.
Too bad that there is a tool missing to mirror the whole object.
A link object could be mirrored, but when fused (boolean) unfold will fail.
To achieve an unfoldable part with both halves fused a clone or one of a pair of link objects has to be flipped (turned by 180°) instead of being mirrored.
Omega Clamp
Workflow Omega Clip:
Make Base Wall,
PartDesign Hole,
PartDesign Fillet,
Unfold.
Hex Bowl
Workflow Hex Bowl:
Make Base Wall,
Make Wall,
6x
Add Corner Relief,
Unfold.
When a Corner Relief is added (right side) it can be necessary to adjust the value of the Size property.
Pen Clip
Workflow Pen Clip:
Make Base Wall,
PartDesign Pocket,
3x
Make Wall,
Unfold.
Extend Face Example
Workflow Extend Face Example:
Make Base Wall,
Make Wall,
Extend Face,
Extend Face,
Unfold.
For the second use of Extend Face a Sketch with two contours is used for shape of the extension(s); and with the value of "use subtraction" set to true it provides the shape for the cut-outs, as well
USB shield contact
Workflow USB shield contact:
Make Base Wall,
Extend Face,
PartDesign Pocket,
Extend Face,
Make Wall,
Unfold.
(The pull relief is just an artistic expression of what could be hidden inside a real plug)