Translations:PartDesign Pad/33/pl: Difference between revisions

From FreeCAD Documentation
(Created page with "==Ograniczenia== * tak jak wszystkie funkcje warsztatu Part Design, Pad tworzy bryłę. a zatem szkic musi zawierać "zamknięty" kształt. Jeśli kształt nie jest "zamknięt...")
(No difference)

Revision as of 16:13, 27 April 2019

Information about message (contribute)
This message has no documentation. If you know where or how this message is used, you can help other translators by adding documentation to this message.
Message definition (PartDesign Pad)
==Limitations==

Ograniczenia

  • tak jak wszystkie funkcje warsztatu Part Design, Pad tworzy bryłę. a zatem szkic musi zawierać "zamknięty" kształt. Jeśli kształt nie jest "zamknięty" pojawi się błąd Failed to validate broken face. W większym szkicu może znajdować się wiele zamkniętych kształtów, pod warunkiem, że żaden z nich się nie przecina (na przykład prostokąt z dwoma okręgami w środku).
  • Algorytmy używane w To First i To Last:
    • Create a line through the centre of gravity of the sketch
    • Find all faces of the support cut by this line
    • Choose the face where the intersection point is nearest/furthest from the sketch
This means that the face that is found might not always be what you expected. If you run into this problem, use the Up to face type instead, and pick the face you want.
For the very special case of extrusion to a concave surface, where the sketch is larger than this surface, extrusion will fail. This is a unresolved bug.
  • v0.16 and below There is no automatic cleanup, e.g. of adjacent planar surfaces into a single surface. You can fix this manually in the Part workbench with Refine shape (which creates an unlinked, non-parametric solid) or with the Refine shape feature from the OpenSCAD Workbench which creates a parametric feature.