Sketcher: Polilinie
Sketcher CreatePolyline |
poziția meniului |
---|
Sketch → Sketcher geometries → Create polyline |
Ateliere |
Sketcher |
scurtătură |
nici unul |
Prezentat în versiune |
- |
A se vedea, de asemenea, |
Sketcher Line |
Descriere
Această unealtă funcționează ca un instrument Sketcher Line, dar crează linii și arce de cerc conectate prin vârfuri/vertex-uri. Când pornește instrumentul, indicatorul mouse se modifică într-o cruce albă și o iconiță roșie tip polilinie. coordonatele indicatorului sunt afișate alături în albastru și în timp real.
Polyline începe cu o linie, un arc de cerc tangent, un arc de cerc perpendicular și apoi cu o linie tangentă
How to use
The polyline always starts with a straight line segment: click - move the mouse - click. Move the mouse again. After placing the first line segment, the Sketcher polyline tool has multiple modes that can be toggled with the M key. For example you can draw tangent or perpendicular arcs following a line or arc segment. Repeatedly pressing the M key toggles through these different modes:
- Press the M key: the new segment is a line which is perpendicular to the previous segment.
- Press the M key again: the new segment is a line which is tangential to the previous segment.
- Press the M key again: the new segment is an arc which is tangential to the previous segment.
- Press the M key again: the new segment is an arc which is perpendicular (left) to the previous segment.
- Press the M key again: the new segment is an arc which is perpendicular(right) to the previous segment.
- Press the M key again: You are again in the state where you started; the line is only connected with a coincidence to the previous segment.
- v0.18 and above While in any of the arc modes, holding down the Ctrl key (MacOS: CMD key) and moving the cursor causes the arc to snap by increments of 45 degrees, relative to the previously created polyline segment.
- Pick points on an empty area of the 3D view, or on an existing object (auto constraints must be active in TaskView).
- Pressing Esc or clicking the right mouse button before closing the polyline to a loop ends the current polyline and you can continue with a new one. Pressing Esc or clicking the right mouse button again ends the polyline function.
- Pressing Esc or clicking the right mouse button after closing the polyline to a loop ends the polyline function.