Part Sphere/ro: Difference between revisions
(Updating to match new version of source page) |
(Created page with "== Descriere == Creează o simplă sferă parametrică, cu parametrii de poziție, unghi1, unghi2, unghi 3 și rază.") |
||
Line 2: | Line 2: | ||
{{GuiCommand/ro|Name=Part Sphere|Name/ro=Part Sphere|MenuLocation=Part -> Sphere||Workbenches=[[Part_Module/ro|Part Module]],Complete|SeeAlso=[[Part_CreatePrimitives/ro|Part CreatePrimitives]]}} |
{{GuiCommand/ro|Name=Part Sphere|Name/ro=Part Sphere|MenuLocation=Part -> Sphere||Workbenches=[[Part_Module/ro|Part Module]],Complete|SeeAlso=[[Part_CreatePrimitives/ro|Part CreatePrimitives]]}} |
||
== |
== Descriere == |
||
Creează o simplă sferă parametrică, cu parametrii de poziție, unghi1, unghi2, unghi 3 și rază. |
|||
Creates a simple parametric sphere, with position, angle1, angle2, angle3 and radius parameters. |
|||
[[File:SimpleSphere.jpg|400px]] |
[[File:SimpleSphere.jpg|400px]] |
Revision as of 17:32, 30 October 2018
Part Sphere |
poziția meniului |
---|
Part -> Sphere |
Ateliere |
Part Module,Complete |
scurtătură |
nici unul |
Prezentat în versiune |
- |
A se vedea, de asemenea, |
Part CreatePrimitives |
Descriere
Creează o simplă sferă parametrică, cu parametrii de poziție, unghi1, unghi2, unghi 3 și rază.
How to use
In the workbench Part click on the sphere icon . The sphere will be positioned at origin (point 0,0,0) on creation. The angle parameters permit to make a portion of sphere instead of a full sphere (they are set to 360° by default).
Options
The parametric sphere is defined by the following parameters:
- Radius
- Angle 1
- Angle 2
- Angle 3
- as well as the standard set of placement parameters
The picture below gives an overview of a parametric sphere with parameters different from the default value.
Parameter
- Radius: Radius of the sphere
- Angle 1: 1nd angle to cut / define the sphere
- Angle 2: 2nd angle to cut / define the sphere
- Angle 3: 3rd angle to cut / define the sphere
Because it is quite difficult to explain the meaning of the parameters angle 1, angle 2, angle 3, the picture below gives an explanation about these parameters with following values: angle 1 = -45°, angle 2 = 45° and angle 3= 90°.