Robot tutorial
Руководство |
Тема |
---|
Robot Workbench |
Уровень |
Beginner |
Время для завершения |
Авторы |
r-frank |
FreeCAD версия |
0.16.6703 |
Примеры файлов |
Смотрите также |
None |
Introduction
This tutorial is here to teach you how to use the Robot Workbench to simulate a robot cell set-up.
Before you begin
This tutorial is written for FreeCAD Version 0.16.6703 or higher. So if you don't have FreeCAD on your computer go to the Download page and do the installation.
This tutorial is targeting on the use of industrial robots and not mobile or service robots (see here).
Setting up a trajectory
- Switch to the Robot Workbench
- Activate the model-tab in the tree view by clicking on it
- Create a new trajectory by clicking on the Robot CreateTrajectory button
- Select the robot in the tree view
- Set home position for robot by clicking on Robot_SetHomePos
- Switch to the Task Panel
- By using the sliders change robot position
- When robot and trajectory are selected in tree view clicking on Robot InsertWaypoint will insert the way-point in the trajectory
- Each way-point is shown with a yellow cross, the waypoints are connected with orange lines
- Define at least three different way points and insert them in the trajectory
Simulating robot movement
- Select robot and trajectory in tree view
- Select simulation by clicking on
- Click on Play-Button I>
- Watch simulation