Part Sphère
Sphère |
Emplacement du menu |
---|
Paramétrique → Sphère |
Ateliers |
Atelier Pièce, Complet |
Raccourci par défaut |
Aucun |
Introduit dans la version |
- |
Voir aussi |
Part CreatePrimitives |
Description
Crée une simple Sphère paramétrique, avec des paramètres de position, de rayon, et d'angles (angle1, angle2 et angle3).La Sphère, sera positionnée, à sa création au point d'origine (0,0,0).
Les paramètres angulaires permettent de tronquer et de créer une révolution incomplète (portion de sphère) au lieu d'une Sphère complète. Par défaut, ils sont définis à -90°, 90°, 360°, et, 5 mm de rayon.
Utilisation
Dans l'atelier Part cliquez sur l'icône . A sa création la sphère est positionnées aux coordonnées d'origine 0,0,0. Les paramètres d'angles permettent de construire une portion de sphère ou une sphère complète (la valeur par défaut est 360°).
Options
The parametric sphere is defined by the following parameters:
- Radius
- Angle 1
- Angle 2
- Angle 3
- as well as the standard set of placement parameters
The picture below gives an overview of a parametric sphere with parameters different from the default value.
Parameter
- Radius: Radius of the sphere
- Angle 1: Angle defined between the y-axis (green arrow) and an imaginary rotating line around the x-axis (red arrow). One end of the line is fixed on the origin. The other end of the line may rotate as said around the x-axis and remain in the XY-plane. The line has the length of the radius of the sphere.
- Angle 2: Test