Translations:Draft Line/5/en

From FreeCAD Documentation
  • To manually enter coordinates enter the X, Y and Z component, and press Enter after each. Or you can press the Enter point button when you have the desired values. It is advisable to move the pointer out of the 3D view before entering coordinates.
  • To use polar coordinates enter a value for the Length and a value for the Angle, and press Enter after each.
  • Check the Angle checkbox to constrain the pointer to the specified angle.
  • Press L to change the focus from the X input box to the Length input box and back. Depending on the input box that receives the focus the Angle checkbox is checked or unchecked.
  • Press R or click the Relative checkbox to toggle relative mode. If relative mode is on, the coordinates of the second point are relative to the first point, else they are relative to the coordinate system origin.
  • Press G or click the Global checkbox to toggle global mode. If global mode is on, coordinates are relative to the global coordinate system, else they are relative to the working plane coordinate system. introduced in version 0.20
  • Press N or click the Continue checkbox to toggle continue mode. If continue mode is on, the command will restart after finishing, allowing you to continue creating lines.
  • Press S to switch Draft snapping on or off.
  • Press Esc or the Close button to abort the command.