Translations:Manual:Modeling for product design/22/zh-cn: Difference between revisions

From FreeCAD Documentation
(Created page with "* 外部几何并不是 "真实" 的,当我们离开编辑模式时,它将被隐藏。但是我们可以用它来放置约束。放置以下 4 个约束: ** 选择矩形的左上点和导入线的顶点,添加一个 16px 水平距离约束,距离为 1.8 毫米 ** 再次选择矩形的左上点和导入线的顶点,添加一个 16px Sketcher...")
 
(No difference)

Latest revision as of 07:08, 14 November 2023

Information about message (contribute)
This message has no documentation. If you know where or how this message is used, you can help other translators by adding documentation to this message.
Message definition (Manual:Modeling for product design)
* The external geometry is not "real", it will be hidden when we leave edit mode. But we can use it to place constraints. Place the 4 following constraints:
** Select the top left point of the rectangle and the top point of the imported line and add a [[Image:Constraint_HorizontalDistance.svg|16px]] [[Sketcher ConstrainDistanceX|Horizontal Distance Constraint]] of 1.8mm
** Select again the top left point of the rectangle and the top point of the imported line and add a [[Image:Constraint_VerticalDistance.svg|16px]] [[Sketcher ConstrainDistanceY|Vertical Distance Constraint]] of 1.8mm
** Select the bottom right point of the rectangle and the bottom point of the right imported line and add a [[Image:Constraint_HorizontalDistance.svg|16px]] [[Sketcher ConstrainDistanceX|Horizontal Distance Constraint]] of 1.8mm
** Select again the bottom right point of the rectangle and the bottom point of the right imported line and add a [[Image:Constraint_VerticalDistance.svg|16px]] [[Sketcher ConstrainDistanceY|Vertical Distance Constraint]] of 1.8mm
  • 外部几何并不是 "真实" 的,当我们离开编辑模式时,它将被隐藏。但是我们可以用它来放置约束。放置以下 4 个约束:
    • 选择矩形的左上点和导入线的顶点,添加一个 水平距离约束,距离为 1.8 毫米
    • 再次选择矩形的左上点和导入线的顶点,添加一个 垂直距离约束,距离为 1.8 毫米
    • 选择矩形的右下点和右导入线的底点,添加一个 水平距离约束,距离为 1.8 毫米
    • 再次选择矩形的右下点和右导入线的底点,添加一个 垂直距离约束,距离为 1.8 毫米